Operation - Panasonic EY-6813 Operating Instructions Manual

.

Operation

Chuck
Note: Grease for bit
Grease the oval indentation
on the bit with the supplied
grease at least once a month.
1. To mount the bit
1-1. Insert a bit into the mounting hole,
and turn it slightly to locate an en-
gaged position.
1-2. At the engaged position, push the
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
2. To dismount the bit
2-1. Depress the chuck cover and pull
the bit.
Foward/Reverse lever
Forward
Be sure to set the switch in the cen-
ter to lock it after use.
Hammering/drilling switching
lever
Speed/Blow Mode selection
lever
1. There are four modes available with
2. Operate the mode change after
Position of
switching
lever
(Rotation with
hammering)
(Rotation only)
Variable speed control trigger
Reverse
To set the center of a hole, pull the trigger
slightly to start the drill rotation slowly.
- 7 -
Operate the Forward /Reverse lever
after the motor rotation is complete-
ly stopped.
the combination of Hammering/
drilling switching lever and Speed/
Blow Mode selection lever.
Select the suitable mode for appli-
cation.
the motor rotation is completely
stopped.
Speed/Blow Mode
selection lever
Hard blow hammer-
ing mode
Soft blow hammering
mode
High speed drilling mode This mode is suitable
Slow speed drilling mode This mode is suitable
Recommended
application
This mode has hard
blow hammering which
is suitable for concrete
drilling.
Concrete drill
This mode is suitable
for concrete drilling
with smaller diameter
drill, or for drilling into
soft base material.
Small diameter con-
crete drill
for metal drilling with
high speed rotation.
Metal drill
Metal hole saw
for wood drill with high
torque.
Wood drill