Propolair BREATHE Manual

Place the diffuser on a flat surface:
•
Insert the power adapter connector 1 into the slot 2,
located at the back of the diffuser
•
Insert the plug 3 into the socket and then press the
POWER button
•
Insert the capsule into the slot inside the diffuser, as
shown in the figure 4 with the open side facing up-
wards.
The POWER led lights up when the diffuser is swit-
ched ON, indicating that the heating process in
alternating phases of the capsule is in progress.
Each capsule is for single use and lasts approximately 122 hours. The END of the cycle of the capsule is
indicated by an acoustic signal Never replace the capsule before.At the end of the cycle, a residue of de-
pleted propolis will be visible inside the glass capsule, now devoid of active ingredients
PROPOLAIR diffusers use only original KONTAK capsules. The processing of propolis and the subse-
quent filling of glass capsules are galenic preparations and require dedicated and specialized machinery.
The use of NOT original capsules may cause a diffuser malfunction, compromising functionality. The
capsules are not refillable.
Please note: do not move the device while in use, as the propolis capsule can be hot and the propolis
might melt during the sublimation process. When replacing the capsule, wait until the device and
exhausted capsule has cooled down
IT IS NECESSARY TO RESET THE OPERATING SYSTEM AT EVERY CAPSULE CHANGE:
1
ON
Turn
the diffuser
CAPSULE MANAGEMENT
2
Hold down the power
button
until the sound stops
OPERATION
3
Replace the used capsule in order
It is possible to enable
to start a new diffusion cycle.
DO NOT FORCE THE CAPSULE
or disable
the IONIZER