Table Of Contents - Panasonic KX-NS Series Setup Reference Manual

SUMMARY
This document is a reference for configuring
and includes the settings required for Incoming Call DDI routing and Outgoing Call CLI presentation.
SIP trunk specific account details are provided to you by
 Attention:
This document was created based on the results of test environment accounts.
Panasonic cannot guarantee SIP Trunk operation in all environments, however as a result of
completing this Inter-Operability Test Panasonic will provide technical support for any issues
experienced an assist as far as possible in providing a resolution.
Please obtain relevant information from Service provider before configuration of SIP trunks.
Panasonic will not be held liable for any information provided in this guidance document.
Information used in this document is for interoperability testing.
Information and Specifications in this document are subject to change without notice.
 Note
When using multiple lines
It is not possible to assign two or more lines to one ID. Make multiple line agreement and obtain
multiple IDs.
Busy
If there are incoming calls when all lines are busy, the caller hears ROT instead of Busy.
Transfer / Forward
When the Transfer/forwarding destination is PSTN, the CLI is not call originator but PBX's CLI.
FAX
Fax that send to PSTN (Call to Japan PSTN) had failures by signaling filtered.
Ringing time
When receiving a call, the bell rings for 1 minute, but on the calling side it keeps calling for about
17 seconds longer.

 Table of Contents

(1) Provisioning a SIP trunk:
(2) Incoming Call Routing:
(3) Outgoing Call CLI:
(4) CLIR Outgoing Call:
(5) Built-in Router and WAN settings:
(6) Packet Filtering Settings:
"I-Net Connect" SIP trunks onto KX-NS Series systems
I-Net Connect.
Page 3
Page 5
Page 6
Page 7
Page 8
Page 10
2