Hasbro Tonka Bounce Back Racer Manual page 2

TO INSTALL BATTERY IN WIRELESS CONTROLLER:
Use a Phillips/cross head screwdriver (not included)
to loosen screw in battery compartment cover
(screw remains attached to cover). Remove cover.
Insert 1 x 9V or 6R61 size battery (not included).
Alkaline battery recommended. Replace cover
and tighten screw.
TO INSTALL BATTERIES IN CAR:
NOTE:
There are two battery compartments; each holds 3 batteries.
Use a Phillips/cross head screwdriver (not included) to loosen screws in battery
compartment covers (screws remain attached to covers). Remove covers.
Insert 6 x 1.5V "AA" or LR6 size alkaline batteries (not included).
Replace covers and tighten screws.
3
3
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to
insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline
batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it
away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries.
Always remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
To conserve batteries, be sure to switch car to "off" when not in use.
NOTE
If toy stops working, turn
:
off vehicle, wait 5 seconds and turn
back on. If it still does not work, turn
off and leave off for 5 minutes.
Then turn on and resume normal use.