Yamaha PW SYSTEM Manual page 44

Main riding
display
[S---]
™ Settings
The display enables the following.
• ClockAdjust (Clock Adjust)
Clock setting
• DistanceUnit (Distance Unit)
km/mile setting
• DisplayItem (Display Item)
Sets the items to be displayed in the function display
during normal riding.
• RecordReset (Record Reset)
Resets the values of the trip meter, average bicycle
speed, maximum bicycle speed, and trip time.
• Brightness
[▲]
[S]
Set the brightness of the display backlight.
[▼]
[▲]
• LightMemory (Light Memory)
[S]
Sets whether to ignore or save the on or off status of
[▼]
[▲]
the headlight when the power of the e-Bike Systems is
[S]
turned off.
[▼]
[▲]
[S]
1. Press the function select switch for 2 seconds or long-
[▼]
[▲]
er.
[S]
2. Select an item by using the assist mode switches (up)
[▼]
[▲]
or (down).
[S]
[▼] When you select an item to set and press the function
[▲]
[S]
select switch, the setting will be displayed.
[▼]
Selecting "EXIT" returns to the main riding display.
WARNING
For all setting procedures, be sure to stop the bicycle
and perform the required settings in a safe location.
Otherwise, lack of attention to surrounding traffic or
other hazards could cause an accident.
TIP
• The settings cannot be adjusted while riding.
• If you do the following during setting, the item that you
are setting will be canceled and the display will return
to the main riding display.
• Turning the crank (pedal) in the traveling direction
• Turning the rear wheel at 2 km/h and more
• Pushing the walk assist switch
[S---] ···· Press the function select switch for 2 seconds or
[S] ······· Press the function select switch
[] ······ Press the assist mode switch (up)
[] ······ Press the assist mode switch (down)
longer
44