Advertisement
Quick Manual
Setup procedure
The setup procedure for the Surface Reflectance
Analyzer is shown below.
Step 1. Starting and ending the device and calibrating
Step 2. Taking a measurement
Step 3. Installing the application software
Step 4. Starting the application software
Step 1. Starting and ending the device and calibrating
1) Press the power button to turn on the measuring device.
2) Perform calibration immediately after the device starts.
Startup screen
Calibration screen
3) To calibrate the measuring device, you use the
accompanying calibration unit.
Check that no dust or stains are on the standard plate,
and set the measuring device in the calibration unit.
4) Press
on the measuring device to execute calibration.
SCAN
When the message "Calibrating" disappears and the main
screen appears, calibration is complete.
Power button
Measuring
device
Standard plate
Calibration unit
2/4
Step 2. Taking a measurement and checking the result
1)
Set the measuring device on the object to be measured,
and press
to execute measurement.
SCAN
When the message "Measuring" disappears and the
main screen appears, measurement is complete.
Measuring screen
Haze
Gloss
Main screen
3) Press
on the main screen to display the 20° one-
dimensional BRDF.
Press
again to display the 60° one-dimensional BRDF.
Press on the main screen the 20° two-dimensional BRDF
and yet again to display the 60° two-dimensional BRDF.
One-dimensional BRDF (20°)
Two-dimensional BRDF (20°)
Image clarity
Advertisement
