Alfa Romeo Giulietta 2010 Manual page 25

To use the voice commands, the voice recog-
nition system does not need time to learn
your voice.
To give the system a voice command, press
'
and wait for the audible signal indicat-
ing that the voice recognition system is ac-
tivated; you can now give the command in
your normal voice - not too quickly, but with-
out interruptions. When the system recog-
nises the command, it will respond or per-
form an action.
The voice commands are divided into level
1, level 2 and level 3.
When a valid* level 1 voice command is giv-
en, the system is prepared to recognise level
2 voice commands; when a valid level 2 voice
command is given, the system is activated
to recognise level 3 voice commands.
If the user gives a valid* level 1 voice com-
mand, the sub-menu for that command re-
mains activated until a voice command that
leads to another level is given or the inter-
action is interrupted; the same rule applies
for the lower levels (2 and 3).
* Valid means that the voice command is part of the system's vocabulary, and can therefore be recognised in a given level.
24
For a list of all the available voice com-
mands, refer to the LIST OF AVAILABLE
VOICE COMMANDS chapter.
To listen again to the last message given by
'
the system, press for more than one sec-
'
ond or briefly press and say "Repeat".
It is possible that the hands-free system will
provide spoken information.
A voice announcement is a voice message
spoken directly by the system. To end a
&
voice announcement, press
'
press and say "Cancel".
A voice interaction is an exchange of commu-
nications/commands between the hands-free
system and the user. To start a voice interac-
'
tion, press and give a command. To stop
an interaction and start a new one, press
at any time during the interaction and give
a voice command.
To end an interaction, press &
will hear a signal indicating that voice recog-
nition has been deactivated.
The help function can provide you, at any
time, with a list of commands available for
the level you are at. To use the help system,
say "Help", listen to the list of commands
available and decide which command you
want to give the system.
Adjust the volume to the level that is best for
you with the vehicle in motion. To adjust the
preset system volume, refer to "CONFIGU-
RATION - SOUNDS - Adjusting and saving as
default" paragraph in the RADIONAV in-
/ESC or
struction manual. To temporarily adjust the
volume of a call in progress, press + or –
or turn the RADIONAV knob. At the end
of the call, the volume will return to its orig-
inal level.
' You can also press + or – to adjust the vol-
ume of a voice announcement while it is be-
ing said by system.
/ESC. You
Remember that to interrupt a voice an-
nouncement you can press
during a vocal interaction and provide a new
voice command.
'
at any time