Summary of Contents for RHINO Premium
- Page 1 Premium 10x10, 10x12, 10x14, 10x16, 10x18, 10x20 Assembly instructions Greenhouses Direct Ltd www.greenhousesdirect.co.uk Service department open Monday to Friday 9am - 5.30pm 0344 493 1929 service@greenhousesdirect.co.uk Rhino Premium 10ft instructions 0721...
-
Page 2: Online Video
Digitally printed on 120gsm Recycled Evolution paper Dynamic Print Norwich capture the CO2 emissions from their paper purchases by planting native woodland, right here in the UK, through the Woodland Trust and the Woodland Carbon scheme. Rhino Premium 10ft wide... - Page 3 10x10 10x12 10x14 10x16 10x18 10x20...
- Page 4 Door stile 1913mm R85/1 Meeting stile 1913mm R86/1 Door x member bottom 614mm R92/9 Glazing Bead long 2347mm R92/57 Door Wool Pile Classic/Premium Fitted R92/58 Guide Rail woolpile Fitted R92/21 Low modulus clear silicone R93/55 Corner Base Anchor R92/14 H Section (Above Door) 588mm...
- Page 5 Part No Description 10x10 10x12 10x14 10x16 10x18 10x20 Length pack 1 R04/3 ridge 10’ long 3113mm R04/4 ridge 12’ long 3731mm R04/5 ridge 14’ long 4349mm R04/6 ridge 16’ long 4967mm R04/7 ridge 18’ long 5585mm R04/8 ridge 20’ long 6203mm R08/11 hd eave 10’...
- Page 6 10x10 10x12 10x14 10x16 10x18 10x20 Part No Description Roof pack R05/10 Heavy glazing bar, 10’ roof 1866mm R07/13 10’ corner roof LH 1866mm R07/14 10’ corner roof RH 1866mm R91/7 Tie rod 1800mm R92/45 glazing bead 10ft roof 1924mm Side pack R05/2 Heavy glazing bar size 1 1492mm...
- Page 7 Hardstanding bases are no problem for the anchored. Even a completely unglazed frame The greenhouse is assembled using aluminium Rhino as the integral base has a wide lip. will need to be anchored down in some way if Introduction bolts & nuts because they will not rust. These there is a possibility of strong winds.
- Page 8 The ground anchors fix to the frame as shown The base on a Rhino is ideally suited to fixing onto before you start fixing it as described in the section “Fitting onto here.
- Page 9 Soil bases Path Please note that on completion of your Rhino, the Path internal and external ramps must be supported. The best way to achieve this is to excavate the soil and lay a path as shown.
- Page 10 See below for full details. correct anchoring. Please note that on completion of your Rhino the internal ramp must be supported. The best Once the base is built, position the greenhouse so that the Inside of the front door base is aligned way to achieve this is to install a path as shown.
-
Page 11: Roof Vents
5th of 6 pages Front Rear The next 2 pages describes the layout of your Rhino and will be referred to later in the instructions. Familiarise yourself with the layout of your Rhino by checking your order/invoice. Your Or side by side like this: frame and glass will be packed according to the specification noted on that document. - Page 12 Plan ahead If you have ordered integral shelving for your greenhouse, you should now slide additional fixings in the channels. Please read separate shelving instructions for more details. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 13 You must also slide a bolt partition bolts for in to each nut channel of the side bases. See accessories drawing top right. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 14 Base rear R72/10 If you have constructed a greenhouse before, please pay special attention to the drawing on the right. The corner sections on a Rhino are fitted in a very different manner to other makes. Top stay rear 1xR32/41...
- Page 15 All nuts must be fitted to the inside of the frame. That you have slid extra bolts in the glazing bar channels for the louvres (if you are fitting in the rear) and for integral R93/54 staging. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 16 Guide rail end cap 2xR93/53 From the Nut and bolt fixings pack R93/56 R93/56 LP1/LP2 M6x11 bolt R90/19 LP1/LP2 M6 nut R90/20 From the Door fixings pack M6 flat nut 4xR90/46 Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 17 9. Make sure to leave the plate fixings finger tight at this point. Repeat for the That you slid 2xM6 flat nut in to each other side. door post. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 18 See top right for more to the corners at all 4 corners. details. That you have bolted the 4 sides of the base together tightly and that the mitres are fitting snugly. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 19 Please also refer to the separate partition instructions. You now have enough bars fixed in place to begin fitting the vent crossbars – please see the next section. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 20 Fit the 4 hanging basket rail brackets to Complete the roof roof. These fit to the bottom of the second a Premium 10ft looking up at the roof. It shows the holes in the corner roof sections. glazing bar then at the ridge just in from what each of the extra bolts is used for.
- Page 21 Check & tick before moving on... Have fitted downpipe brackets (this is tricky once it is glazed so make sure you have done it now). Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 22 If you are fitting your Rhino onto soil or Now fit the other end support at the same height if you are digging holes to anchor the greenhouse then please refer back to at the rear of the greenhouse.
- Page 23 The size and layout of your Rhino. glazing bar should be fitted to the top side. The small bolts will be inserted from the underside...
- Page 24 Once the glass is in the frame, slide it fully down so that it sits flush into the vent cill. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 25 2 x K - 605x512 Flush door stile Flush door stile Are the door wheels held securely whilst R83/1 R83/1 still turning freely? Fit the glazing rubber as shown above. Rubber Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 26 Door transom arrow D. R16/1 Repeat this for the other door. Door cross-member bottom R86/1 Check & tick before moving on... The door wheel is free to spin Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 27 Have you fitted glazing rubber to the corners, glazing bar and door posts? Have you fitted glass pane T 192mm and your louvre frames? Have you fitted louvre end caps? Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 28 Note also that it must be fitted this way up with Just as you see on so many DIY television environment. the longer sides facing down. programmes WEAR SOME SAFETY GOGGLES. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 29 Continue to glaze the rest of the rear in the same way. Still on this pane fully clip the long glazing bead all the way to the top of the glazing bar. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 30 That you have fitted the roof vent stops. WD40 to the circular part of the hinge before If your greenhouse has more than one vent inserting in to the ridge Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 31 R31/4 Position the door stop bracket level with Door track the lower door transom and tighten the R18/3 R90/47 repeat for the other door post. Lower door transom Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 32 WHEN LOCKING THE VENT YOU MUST FIRST FITTING THE BRACKET OF ALL DISCONNECT THE AUTO VENT BY REMOVING THE CYLINDER RETAINING PIN AND REMOVE THE CYLINDER FROM ITS HOUSING. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 33 Fitting the louvre glass Slide the louvre panes in to the carriers from the top, this will be made easier if you have the louvre in the open position. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
- Page 34 We have used standard 32mm waste pipe made Finial by Osma. The finial is the last item to be put on your greenhouse, please see the separate finial instructions. Rhino Premium 10ft wide Please note: Drawings are not shown to scale...
Need help?
Do you have a question about the Premium and is the answer not in the manual?
Questions and answers