Table of Contents
Advertisement
RELEASE INSTRUCTION
In case of fault or power failure, insert and turn the key
anticlockwise, completely open the cover. Manually open the
gate. To lock the gate again, shut the cover, turn the key
clockwise and remove the key .
Attention: Perform locking and lock release operations
with motor cut off.
Attention: With the cover closed and the key in a horizontal
position, the lock release microswitch is open, thus preventing
any operation.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential
part of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been
expressely designed.
Any other use is to be considered improper and therefore
dangerous.
The manufacturer cannot be held responsible for possible
damage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving
mechanical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the
reach of children, in order to avoid possible involuntary activation
of the motorised door or gate.
In case of breack down or malfunctioning of the product,
disconnect from mains, do not attempt to repair or intervene
directly and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the
motorised door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
OPERATING INSTRUCTION FOR SLIDING GATES
90˚
90˚
OFF
OFF
ON
OFF
Installer:
GB
ON
ON
Advertisement
Table of Contents
