Table of Contents
Advertisement
Quick Links
Installation and Wiring Instructions
Mixed Flow In-Line Fan Range
PLEASE READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS.
UMD PRO
UMD100SX-PRO
UMD100TX-PRO
UMD125SX-PRO
UMD125TX-PRO
UMD150SX-PRO
UMD150TX-PRO
UMD200SX-PRO
UMD200TX-PRO
220-240V~50Hz
PLEASE SAVE THESE INSTRUCTIONS
IP44
Advertisement
Table of Contents
Related Manuals for National Ventilation Monsoon UMD PRO Series
Summary of Contents for National Ventilation Monsoon UMD PRO Series
- Page 1 Installation and Wiring Instructions UMD PRO Mixed Flow In-Line Fan Range UMD100SX-PRO UMD100TX-PRO UMD125SX-PRO UMD125TX-PRO UMD150SX-PRO UMD150TX-PRO UMD200SX-PRO UMD200TX-PRO 220-240V~50Hz PLEASE READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS. PLEASE SAVE THESE INSTRUCTIONS IP44...
- Page 2 Installation and Wiring Instructions for the UMD PRO IN-LINE FAN range. IMPORTANT: READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION DO NOT install this product in areas where the following may be present or occur: • Excessive oil or a grease laden atmosphere. •...
- Page 3 INSTALLATION. The unit is designed as an in-line duct fan to be positioned between lengths of ducting. Short duct runs terminating close to the fan (i.e. within 1.5m) must incorporate suitable guards unless the fan is mounted higher than 2.1m above the floor. If flexible ducting is used it should be fully extended to obtain the best results.
- Page 4 WIRING. WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER SUPPLY DURING THE INSTALLATION / OR MAINTENANCE. THE FANS ARE DOUBLE INSULATED AND CARRY A MARK. THERE ARE NO EARTH TERMINALS AND THESE FANS MUST NOT BE EARTHED. 1.
- Page 5 Speed Adjustment The fan has three speeds which are selectable by changing the position of the jumper. The fan is factory set to Setting 3 - High speed. To change the speed setting, pull the jumper off the header pins and place back onto the desired position, see Fig14.
- Page 8 National Ventilation Stathe Road Burrowbridge Somerset TA7 0RY EU Authorised Representative: National Ventilation Bedrijvenweg 17 7442 CX Nijverdal Nederland authorisedrep@nationalventilation.nl Website: www.nationalventilation.co.uk email: info@nvagroup.co.uk Sales and technical hotline: 01823 690290 494754 D 0921...
Need help?
Do you have a question about the Monsoon UMD PRO Series and is the answer not in the manual?
Questions and answers