Table of Contents
Advertisement
• Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you must use an extension cord, the cord
shall be rated to 13A (Minimum conductor size
1.5mm2) and if the cord is on a reel it must be fully
unwound before use.
• Disconnect the power cable from the electrical supply
when the heater is not in use. If the power cord
becomes damaged, it must be replaced by a qualified
electrician.
• One dark point may exist on the surface of the heating
elements during the first few minutes after it is turned
on. This is normal, and will not affect the performance
of the unit.
• To avoid fire or shock hazard, plug the unit directly into
a 220-240V and 13A electrical socket outlet
• WARNING! These appliances must be earthed. Before
installing or replacing the bulb, the appliance must be
disconnected from the 220-240V mains supply.
IMPORTANT NOTE:
Tip Over Switch
• This appliance is fitted with an internal tip over switch,
this means if the unit is tilted more than 45 degrees the
unit will automatically turn off.
• This is a safety feature and is designed to prevent
damage, fire and personal injury.
• If the unit is put back in the upright position the unit will
automatically turn on and will operate as normal.
8
Revision 1.2
Advertisement
Table of Contents
