Trolley Check - Id.14A0 - Smeg WD6010 User Manual

11.13 TROLLEY CHECK – ID.14A0
[The Trolley Check function can only be used if the "RACKREC" optional is correctly installed on the device,
with the "MAGBAR" optional installed on the racks.
The firmware includes this function with effect from the Master CPU version 11.2.0, issued in February 2019.]
The purposes of this function are:
1. To allow detection of the presence of the rack in the chamber;
2. To recognise the rack type;
3. To associate a specific washing cycle to a specific rack.
4. To save the ID of the rack used on file and print it out.
Presence of the "Trolley Check" optional is set in the factory and can be verified by the authorised tech user.
The operator – if he has a superuser password – can:
1. Enable or disable its operation;
2. Associate the relevant program to each coded rack.
All racks for which the check function is to be used must be fitted with the relevant "MAGBAR" optional.
After consulting the authorised tech user, the operator must assign the code to the racks directly, by
arranging the magnetic elements of the optional accordingly.
N.B.: in alarms and on screens, the terms "Rack" and "Trolley" are used as synonyms.
The washing rack zone on which the coding magnets are installed are highlighted in the photograph
below.
The photograph shows the rack viewed from the left, loading side. The arrows indicate the direction of
loading in the washing chamber. B1, B2, B3, B4 and B5 are the elements used for setting the rack code.
USER MANUAL WD6010 – WD7010 – WD7015 Page 103 - 168