RYTEC Widescan 1210761-0 Manual page 6

BEA Widescan accessory guide
How to set the controller parameters for the BEA Widescan
If you don't know how to set a parameter, follow the steps in How to set a controller
NOTE:
parameter at the end of this guide..
These parameters must be
Parameter Value for
Number BEA Widescan
50B 0502
50C 0502
5B9 9
5C9 9
How to wire the sensor
Set the disconnect switch to the OFF position and perform a lockout/tagout
of the high-voltage disconnect before installing wiring to the controller.
Do not set the disconnect switch to the ON position until the wiring installation is
complete and the controller is fully earth grounded per instructions.
Failure to comply could result in shock, burns or death.
1
Open door to fully open position,
power and perform
2
#2
The cable must enter through the bottom of the control box.
▪
control box voids the warranty for the door.
Low voltage cables must enter
▪
Holes must be drilled.
▪
6
checked and, if necessary, changed.
disconnect
lockout/tagout.
through the right side
The indentations on the controller bottom are not knockouts.
WARNING
3
If necessary,
the Audible Alert System cable.
High voltage
■
NOTICE
Drilling through the top or side of the
of the box bottom.
drill a hole in the control box for
Low voltage
■
1 2 1 0 7 5 9 - 0 R e v 0 1
■
0 6 / 2 0
■