EcoScapes GALAXY WAVE 70643, 70643-1/DK1 - Smart Projector Manual

Operation

USB-C Power

Plug USB-C end of power cable into product and USB-A end into 5V, 2A power source (adapter not included).

Manual Operation

Power Button
Press to turn ON/OFF — will return to last setting used when turned back on.

• Pairing Mode Reset - Press and hold the power button until thedome flashes to enter pairing mode.
• 6hr Timeout – The projected image automatically turns off after 6 hours — lasers and effects will remain on.

Color Wave
Press to change the color of the wave effect. Press and hold to adjust brightness — the dome will flash when the highest/lowest level has been reached. (See Wave Button Guide)

Sleep Sounds
Press to cycle through each sound. Press and hold for volume control — the dome will flash when the highest/lowest level has been reached. (See Sleep Sounds Guide)

Preset Modes
Press to change between 10 preset combinations of effects and sounds. (See Presets in app)

Wave Rotation Speed
Press to change between pause, slow, medium-slow, medium-fast, fast. Press and hold to reset to factory settings — the dome will flash when factory settings are reset. App settings will not reset and device will still stay connected to your phone.

Projected Image and Lasers
Press to cycle through each image combination. Use the scroll wheel on the side of the projector to change the image. Press and hold to adjust the laser's brightness — the dome will flash when the highest/lowest level has been reached. (See Projection and Laser Button Guide)

DO NOT stare or look directly into the LED dome, laser emitter or image projector as this can be hazardous and can damage your eyes.

Projector Placement

• You can use the geometric design of the smart projector to point thelight where your want.
• You can set the projector onto the included anti-skid pad. Peel off the pad's plastic backing and stick it onto the surface were the projector will be set. Make sure the surface is clean and dry.
• The lower the projector is in the room, the larger the projected image will be.

Remotely operate your smart Galaxy Wave Projector with the easy-to-use Enbrighten app. Follow the available instructions and resources to set up your smart device.

Download the app

Scan the QR code or search Enbrighten on the Apple App Store or on Google Play.

Setup and installation

1. Create an account in the Enbrighten app
   
2. Plug in the smart Galaxy Wave Projector
   
3. Add devices, control the smart Galaxy Wave Projector from anywhere and create schedules
   

Voice control

Works with Amazon Alexa or Google Assistant-enabled devices

Select "Support" in the Enbrighten app or follow the steps in the Amazon Alexa or Google Home app to connect your Enbrighten account

Sleep Sounds Guide

Projected Image and Laser Guide

Color Wave Guide

Videos

EcoScapes GALAXY WAVE 70643 Manual Operation Video

EcoScapes GALAXY WAVE 70643 Setup & Pairing Video

Documents / Resources

References

• App Store - Apple
• Google Play

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download EcoScapes GALAXY WAVE 70643, 70643-1/DK1 - Smart Projector Manual