Kyocera TASKalfa 3554ci Setup Procedure page 8

[Other setup information]
･
Command Center RX default password
From this product, the default password to access from Command Center RX (Web
browser) has been changed.
ID: "Admin"
Pass: Serial Number of each device
You can confirm the serial number to open the Configuration page of CommandCenter
RX or Device Information screen of Operation Panel.
If you change the password to different value and then execute the initialization
function, it will return to this default value.
･
Install printer driver
You can install the Printer Driver from ProductLib files.
Please perform the following installation steps:
1. Copy the "ProductLib" folers to your PC any directly.
2. Launch [Devices and Printers] from [Control Panel].
3. Click [Add a printer].
4. Click [The printer that I want isn't listed].
5. Select [Add a local printer or network printer with manual settings] and click [Next].
6. Select [Create a new port:].
7. Select [Standard TCP/IP Port] and click [Next].
8. Add printer IP address to [Hostname or IP address] and click [Next].
9. Click [Have Disk...] .
10. Click [Browse...].
11. Select <OEMSETUP.INF> from <...¥ProductLib¥KXDriver¥64bit> and click [OK]. *
If your PC is 32bit, select the "32bit" folder.
12. Select model name and click [Next].
13. Confirm model name and click [Next] and KX Driver installation will be started.
14. Click [Finish] after KX Driver installation.
In the above installation only, the printer driver is connected with the RAW port. In
the security test environment, it have to use IPPS, so the following steps are required.
At first, you need to install the certificate of MFP to your PC.
1. Open the CCRX.