SUNBELL SUNCEN Instructions Manual page 17

USE INSTRUCTIONS
WALL BUTTONS AND REMOTE CONTROL
Power
Keep the button pressed for 1 second. The
white LEDS corresponding to the selected blinds
turn on (the last selection made is saved).
Blinds selection
Select the blinds by using the
The flashing of the white LED indicates the current
blind.
Press the button to select the blind: a slower
flashing of the white LED indicates that the
selection is made.
The white LEDS steadily lit indicate the selected
blinds. Therefore, it's possible to raise or lower single
blinds, a group of blinds or all the blinds
simultaneously.
Simultaneously press (for 1 second) the
buttons to select or deselect all the 12 blinds.
Raising, lowering and tilting the blinds
Press or button to raise or lower the blinds.
To change direction of the blinds' movement stop it by pressing the
button.
Keep or button pressed to raise or lower the blinds in slow mode.
Keep or button pressed to tilt the slats (function not available with fabric blinds).
The blue flashing of the
Stopping the blinds
Press the button to stop the moving blinds. The blue LED flashing indicates the
transmission of the command.
Stand by
The remote control turns off after a 20 seconds inactivity. Every LED turn off.
Recharging the remote control
The red flashing of the
buttons.
and
LED indicates the transmission of the command.
led indicates the need to recharge the remote control.
button, then press
EN
or
16