CONTENTS - Safety precautions p. 4 - Cleaning p. 5 - Installation p. 6 - Operation p. 7 p. 7 Exiting scan mode p. 7 Setting target programs p. 7 Resetting your monitor - Data readouts p. 8 - Troubleshoot p.
SAFETY PRECAUTIONS The monitor on this machine has been tested to the required standards, each of those passed regulations are shown via the following symbols: WEEE - Waste Electrical and Electronic Equipment Recycling. ABS - Acrylonitrile Butadiene Styrene often referred to as ABS is a type of plastic that is an opaque thermoplastic. CE - The product conforms with relevant EU directives regarding health and safety or environmental protection.
CLEANING Please take care when cleaning this monitor as the LCD screen can easily be scratched. You will need a soft dry cloth Do not spray cleaning chemicals directly onto the monitor Do not apply water to the monitor as it is electrical and may damage the internal components...
INSTALLATION STEP 1 STEP 2 Insert the batteries, making sure they are the Remove the four screws from the back of the correct way round. monitor. STEP 3 STEP 4 Connect the male to female wires from the base Secure the monitor to the base using the four to the monitor.
OPERATION The JF150 monitor has a total of 6 readouts, displaying: Time Speed Distance Heart Rate Calories Odometer When first powered on, the monitor will automatically be in ‘Scan’ mode. This means the digits in the largest segment on the screen will change every few seconds between time, distance, speed etc. This will allow you to have an overview while training without pressing any buttons.
TROUBLESHOOT Issue Resolutions No power to the monitor • Make sure the batteries are fully inserted and the correct way round. • Check your connection wires from the monitor to the base. They must not be trapped, fully connected and the pins must be straight.
Need help?
Do you have a question about the JF150 and is the answer not in the manual?
Questions and answers