SOMFY Situo 5 Variation RTS II - Remote Control Manual

SOMFY Situo 5 Variation RTS II - Remote Control Manual

Advertisement

SOMFY Situo 5 Variation RTS II - Remote Control Manual

Safety and liability

The Situo 5 Variation RTS II allows up to 5 groups of one or more applications to be controlled.

Liability

These instructions must be kept by the user. Failure to follow these instructions or use of the product outside its field of application is forbidden, and will invalidate the warranty and discharge Somfy of all liability.

This Somfy product must be installed by a professional motorisation and home automation installer. Moreover, the installer must comply with standards and legislation currently in force in the country in which the product is being installed, and inform his customers of the operating and maintenance conditions for the product.

Never begin installing without first checking the compatibility of this product with the associated equipment and accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy adviser or go to the website www.somfy.com.

Safety instructions

  • Do not use or install this product outdoors.
  • Keep the product out of reach of children.
  • Do not knock or drop the product, expose it to flammable materials or sources of heat or moisture, or splash or immerse it.

The Situo 5 Variation RTS II in detail

The Situo 5 Variation RTS II in detail

  1. Wall mounting recess
  2. Up/On/Open button
  3. STOP/my button
  4. Dimmer
  5. Down/Off/Close button
  6. Button activation and group selection indicator lights
  7. Group selector
  8. PROG button
  9. Wall mounting.

Group selection

Group selection

  • Before performing any operation with the Situo 5 Variation RTS II, check that the correct group has been selected.

Press repeatedly on the group selector to select the correct group.
The indicator light for each group from 1 to 4 is lit individually then all the indicator lights are lit if group 5 is selected.

Installation

Adding/deleting a Situo 5 Variation RTS II

information To program the first control: refer to the instructions for the RTS motor or receiver.

To add or delete the Situo 5 Variation RTS II to or from an application:
Adding/deleting a Situo 5 Variation RTS II

  1. On the individual control already associated with the application:
    • Press the PROG button (≈ 2 s) until the application moves up and down.
  2. On the Situo 5 Variation RTS II to be added or deleted.
    • Select the group.
    • Briefly press the PROG button: the application moves up and down and the Situo 5 Variation RTS II is added or deleted.

Fastening

Fastening

  1. Remove the protective film from the adhesive on the back of the wall mounting.
  2. Fasten the wall mounting to a flat, clean and dry surface. Press for optimum bonding.
  3. Place the Situo 5 Variation RTS II on the mounting.

Use

  • Before using the Situo 5 Variation RTS II, check that the correct group has been selected.

Group selector

This allows the group to be displayed and changed (5 groups are available):

  • Short press: visualisation of the group selected.
  • Press several times: change of group.

information Group 5: all 4 indicator lights come on together.

Buttons Up / On / Open; Down / Off / Close

Buttons Up / On / Open; Down / Off / Close

Depending on the type of application to be operated: /

  • : Up / On / Open
  • : Down / Off / Close

Variator

Variator

Used to:

  • vary the angle of the adjustable slats on Venetian blinds
  • vary the lighting and heating.

information Scroll 1 notch: slats tilted 1 notch, lighting and heating changed per variator notch.
Scroll n notches: tilt the slats by n steps, vary the lighting and heating by n steps.

STOP button / my

STOP button / my

  • Briefly press to stop the application from being activated.
  • If the application has been stopped, briefly press to activate it until the favourite position (my).

Setting, modifying or deleting the favourite position (my)

Setting, modifying or deleting the favourite position (my)

  • Place the application in the required position then press(≈ 5 s) to set the favourite position (my).
  • Place the application in the favourite position (my) and press (≈ 5 s) to delete it.

Tips and recommendations

To replace the last RTS control point lost or broken, contact a motorisation and home automation professional.

Replacing the battery

Replacing the battery

Following the figure, remove the rear panel from the remote control, replace the battery with a new one with the same characteristics then close the panel.

warning Risk of explosion if the battery is replaced by an incorrect type.

warning Keep new and used batteries away from children.

warning Do not ingest battery. If the battery is swallowed, it can cause chemical burns in just 2 hours and can lead to death. If you think this occurred, call a doctor immediately. If the battery compartment does not close securely, stop using the product and keep it away from children.

warning Do not throw onto a fire as there is a risk of explosion.


Please separate storage cells and batteries from other types of waste and recycle them via your local collection facility.

Technical data

Frequency range and maximum power used:

  • Japan: 426 MHz - 426.0625 MHz, e.r.p. < 1 mW
  • Korea: 447 MHz - 447.700 MHz, e.r.p. < 5 mW
  • U.S.A. : 433.050 MHz - 433.42MHz, 19.9μW average e.r.p.

Radio range: 20 m between two walls.
Operating temperature: 0°C to +50°C
Power supply: 1 type CR2430 battery, 3 V

This device complies with Industry Canada's licence-exempt RSSs.
Operation is subject to the following two conditions:

  1. This device may not cause interference; and
  2. This device must accept any interference, including interference that may cause undesired operation of the device.


FCC warning statement:

  • This device complies with Part 15 of the FCC Rules.
    Operation is subject to the following two conditions:
    1. This device may not cause harmful interference, and
    2. This device must accept any interference received, including interference that may cause undesired operation.
  • This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
  • Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

SOMFY ACTIVITÉS SA
50 avenue du Nouveau Monde F - 74300 Cluses
www.somfy.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download SOMFY Situo 5 Variation RTS II - Remote Control Manual

Advertisement

Need help?

Need help?

Do you have a question about the Situo 5 Variation RTS II and is the answer not in the manual?

Questions and answers

Table of Contents