Moultrie Super Pro Magnum Feeder Instructions

HARDWARE INCLUDED:
Combination Drive Screw
Qty. 3
(¼"-20 x 4")
A

DRILLING YOUR DRUM OR BARREL

NOTE: If you purchased a Moultrie barrel, go to Step B
Super Pro Magnum Kit will mount to the bottom of any drum or barrel
Turn drum over, measure and mark the center of the bottom.
Mark where holes of kit are on the bottom of the drum.
Drill three 5/16" Feeder Leg Holes.
Using a Hole Saw, drill a 2.25" hole in the center of the
bottom of your drum.
B

MOUNTING THE FEEDER

From the inside of the drum, put flat washers on the 1/4-20 x 4"
Combination Drive Screws then slide through the holes in the
bottom of the barrel and screw the push nuts onto the bolts on
the outside of the barrel.
Turn grooved handle counterclockwise one click . This will release
the battery cover from the feeder kit. Battery cover can be pulled
off straight downward and set aside.
NOTE: Grooved handle should stay assembled with battery cover.
DO NOT FORCE THE GROOVED HANDLE COUNTERCLOCKWISE
AN ADDITIONAL CLICK. This will disassemble the grooved handle
from the battery cover and can cause wear on the parts that
retain this assembly.
Slide feeder over three Bolts that are sticking firmly through
the bottom of the drum. Attach Feeder Kit to the Drum
using the three provided Wing Nuts.
MFG-13455_Super Pro Magnum Kit_Manual-ENGLISH_4-19-22.indd 1 MFG-13455_Super Pro Magnum Kit_Manual-ENGLISH_4-19-22.indd 1
Instructions for Super Pro Magnum Feeder
Thank you for your purchase of the Super Pro Magnum Feeder. Please read this sheet
before operating the unit. If you should have any questions about this product or any other
Moultrie product, please contact us using the information on the back of this sheet.
Flat Washer
Qty. 3
(¼")
Bolts
Drum
Push Nut
Qty. 3
(¼")
Combination
Drive Screw
Flat Washer
Push Nut
Wing Nut
Qty. 3
(¼")
Wing Nuts
Super Pro Magnum
Feeder Kit
4/19/22 9:56 AM 4/19/22 9:56 AM