Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Haltech WB1
- Page 1 WIDEBAND CONTROLLERS WB1 / WB2 QUICK START GUIDE...
-
Page 2: Product Overview
NSP, ESP or ECU Manager software. • Oxygen Sensor Adaptor Harness • (2) Oxygen Sensor Adaptor Harnesses There are two versions of WB1 and WB2 controllers, • 303SS Oxygen Sensor Bung • 303SS Oxygen Sensor Bung each version will control one of the following sensor •... - Page 3 CAN Bus circuit The Haltech Wideband Controller can be mounted to a Connect the controller to the Haltech CAN Bus on your delivers. flat surface in the engine bay using the two mounting ECU by the integrated DTM-4 connector on your device.
- Page 4 Connect the Haltech CAN Wideband Controller directly (Red/Blue). (Red/Blue). to a Haltech Elite Series ECU using the included DTM-4 to a Haltech Elite Series single connector ECU using the Power supply cable and CAN cable DTM-4 to DTM-4 in Connect the DTM-4 Power supply cable BLACK wire...
- Page 5 ECU as shown below. your specific ECU’s Quick start guide for reference and Haltech WB1 connected to an Elite Series ECU with Plug’n’Play adapter. locations. HT-130051 Connect the DTM-4 Power supply cable RED power (CAN plug for single connector ECU Plug’n’Play kits only)
- Page 6 Wiring for NEXUS R5 ECU The NEXUS R5 includes three separate CAN buses, Haltech WB1 connected to NEXUS R5 VCU through CAN Network 2 users must select ONE HALTECH CAN network for unit NOTE: CAN Network 1 or 3 may also be configured for this purpose.
-
Page 7: Sensor Installation
ESP Software Setup NSP Software Setup The best location for the sensor is approximately 1 If two or more Haltech WB devices are connected to an With the Haltech CAN Wideband Controller installed, it Now that your Haltech CAN Wideband Controller is metre (3’) from the closest exhaust valve (measured... -
Page 8: Product Specifications
(with its sealed packaging in tact) for credit only (no refunds given) and will installing any Haltech product. be subject to a 10% restocking fee. ** Sensors are compatible with specific WB1/WB2 Controllers. ie. NTK WB1 only compatible with NTK sensor. - Page 9 11/2022 Haltech Australia Haltech USA East Haltech UK 17 Durian Place, 750 Miles Point Way, Unit 1, Miras Business Estate, Wetherill Park NSW 2164 Lexington, KY USA 40510 Keys Park Road, Hednesford, Australia Phone: (888) 298 8116 WS12 2FS Phone: +61 2 9729 0999 Email: usa@haltech.com...
Need help?
Do you have a question about the WB1 and is the answer not in the manual?
Questions and answers