Table of Contents
Advertisement
On/Off
This button indicates equipment status: on or off. When the
equipment is on, the button indicator is lit up.
Cold rinse cycle
This button starts a cold rinse cycle at the end of the selected
wash cycle. When the cycle is selected, the button indicator is
lit up. This cycle remains active for all the wash cycles.
Particularly suitable for rinsing glasses.
Drain / self-cleaning cycle
This button starts a drain/self-cleaning cycle. When the cycle is
selected, the button indicator is lit up.
Wash cycle 1
This button starts Wash cycle 1. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing not very dirty dishes.
Wash cycle 2
This button starts Wash cycle 2. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing normally dirty dishes.
NOTE!
If the dishwasher has only 2 wash cycles, this
cycle is recommended for washing very dirty
dishes.
H
COMMISSIONING
H.1
Preliminary checks, adjustments and
operational tests
WARNING
These operations must only be
carried out by specialised techni-
cians provided with adequate
personal protection equipment
(e. g. safety footwear, gloves,
glasses, etc.), tools and suitable
ancillary equipment with the
appliance switched off and cold.
Wash cycle 3
This button starts Wash cycle 3. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing very dirty dishes.
Active/Wash Safe Control indicator
In the Active/Wash Safe Control
models a special device checks
the temperature of the rinse phase.
The
SYSTEM [GRS] is an automatic
rinse
system.
The GUARANTEED RINSE SYSTEM is active:
• during the wash cycle and the indicator light is OFF;
• during the rinse cycle and the indicator light comes on and is
GREEN;
• at the end of the rinse cycle. The indicator light is GREEN if
the rinse temperature and time have been carried out as per
the programme, otherwise the indicator light is RED;
• upon opening the door, the indicator light GOES OUT.
NOTE!
If the indicator light is RED, wait for a couple of
minutes and then repeat the wash cycle.
Electrical and plumbing checks
Before starting the machine:
• check correct connection of the electrical wires that feed the
machine;
• make sure the power supply voltage and frequency match
the data given in the technical data table (D TECHNICAL
DATA);
• check correct connection of the water supply and drain
pipes (see paragraph F.6 Plumbing connections);
• make sure all the guards, safety devices and emergency
switches are in place and efficient.
GUARANTEED
RINSE
time/temperature
control
23
Hide quick links:
Advertisement
Table of Contents
