Advertisement
Quick Links
CitySpirit Street
BDS480/BDS482
Mounting instruction
IEC
60598
BDS480 LED37/NW PSU 220-240V DW2 MP1 AUS
BDS480 LED35/WW PSU 220-240V DW2 MP1 AUS
BDS480 LED76/NW PSU 220-240V DW2 MP1 AUS
BDS480 LED70/WW PSU 220-240V DW2 MP1 AUS
BDS480 LED35/WW PSD 220-240V DW2 MP1 AUS
BDS480 LED37/NW PSD 220-240V DW2 MP1 AUS
BDS480 LED76/NW PSD 220-240V DW2 MP1 AUS
BDS480 LED70/WW PSD 220-240V DW2 MP1 AUS
BDS482 LED37/NW 220-240V GRN AUS
BDS482 LED37/NW 220-240V BL AUS
BDS482 LED37/NW 220-240V RD AUS
BDS482 LED35/WW 220-240V GRN AUS
BDS482 LED35/WW 220-240V BL AUS
BDS482 LED35/WW 220-240V RD AUS
*：Dimming by program in IC inside power supply.
*Pole diameter 60mm
Philips Lighting (China) Investment Co., Ltd.
No. 9, Lane 888 Tianlin Rd, Shanghai, China
Pos talcode: 200233
IP65
Type
Power
38W
75W
38W
75W
46W
ta
S.Cx
IK09
40°
0.32m²
Control
Voltage
Color Ring
Method
on/off
No
Dimming *
220-240V
Red
on/off
Green
Blue
640
AS/NZS
60598
CCT/Color
Frequency
13.7
3000/4000K
50/60Hz
12
50mm
8mm
Unit: mm
单位: mm
Application
kg
Temperature
－40 ～ 40
Advertisement
Related Manuals for Philips CitySpirit Street BDS480
Summary of Contents for Philips CitySpirit Street BDS480
- Page 1 BDS482 LED35/WW 220-240V BL AUS BDS482 LED35/WW 220-240V RD AUS *：Dimming by program in IC inside power supply. 50mm *Pole diameter 60mm Unit: mm 单位: mm Philips Lighting (China) Investment Co., Ltd. No. 9, Lane 888 Tianlin Rd, Shanghai, China Pos talcode: 200233...
- Page 2 Pole Mounting 16Nm 1.Put luminaire on the top of pole and diameter of pole is 60mm at junction; 2.Use hexagon socket screw key to tighten two screws, torque is 16 N.m. Driver Maintenance 或 1. Open clip; 2. loosen screws at input end of power supply; 3.
- Page 3 Glass Maintenance 1.Glass maintenance is only for non-color ring version, color ring version should be maintained in factory; 2.Use 3mm hexagon socket screw key to loosen fives screws to fix glass; 3.Take off damaged glass; 4.Replace good glass with damaged glass, don t forget plastics washer and sealing ring, then tighten screws.
- Page 4 NOTES: 1.The luminaire should be installed by a qualified electrician and wired in accordance with the latest IEE electrical regulations or the national requirements. 2.Do not switch on before complete installation. 3.Don't hot swap. Don't operate when power on; Don't touch the lamp or the heating part, etc. 4.First switch off main supply and then replace broken glass.