Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Wimius H7
Summary of Contents for Wimius H7
- Page 1 INVISIBLE TRAIL CAMERA User Manual...
-
Page 3: Dear Customer
Dear Customer; Thank you for purchasing WiMiUS H7 Hunting Camera. Please read the user manual carefully before you start to use the product. Please note that items purchased from WiMiUS are covered by 2 year warranty. Your package should include: 1. - Page 4 Preface Thank you so much for purchasing our Trail Camera. This device is a special camera for recording and observing wildlife. For your easy operation, we provide detailed use manual about safety and usage. To obtain the best performance, please read this manual carefully before using. Only use this product as described and for the specified areas of application.
- Page 5 Camera and Accessories Trail Camera*1 Metal bracket *1 Mini USB cable *1 Long screw of metal bracket *3 Mounting belt*1 Plastic expansion tube *3 User manual *1 Structure 1. Infrared LEDs 2. Lens 3. Speaker 4. PIR Detector 5. 2.0” Display Screen 6.
-
Page 6: Power Supply
Power Supply Insert batteries before use. ● Open the camera and remove the battery cover. Insert 1.5V AA batteries of 4 or 8 pcs while preventing some of the anti-access battery polarity. ● Make sure all batteries are in the same battery case when using only 4 pcs. Otherwise the device will not work and can be damaged. -
Page 7: Setting & Operation
Setting & Operation Power on/off Set mode switch to "TEST"/ "ON", the camera turns on. (The LCD will be closed after 5s in the "ON" mode.) Switch to the "OFF", and then it turns off. ● ON status: Switch from TEST to ON, the red light will be flash. After the countdown, red light and display screen will be off and the camera gets into standby mode. - Page 8 Capture Num The camera can set to capture 1 photo, 2 photos or 3 photos continuously. Video Length Set the length of capturing video (5S / 10S / 20S / 30S / 60S / 3mins / 5mins / 10mins). The system default is 5 seconds.
-
Page 9: Aligning The Camera
Aligning the Camera In the “TEST” mode, you can work out the best possible detection angle and range of the PIR detector. Steps are as follows: Attach the camera to a place where about 1m-2m from ground. Adjust the lens angle and move to the other side slowly to see the trace. -
Page 10: Installing Bracket
Playback Firstly, remove the camera away from the installation position. Long press the OK button to enter playback mode after selected“TEST”. Press Up or Down button to check all photos and videos. When replay videos, press the OK button to start playing and press it again to pause. Press the Up button to fast forward and the Down button to fast backward. -
Page 11: Files Download
Steps: ■ Use the drilling machine with 6mm drill to punch mounting holes in the place you want. ■ Insert the plastic expansion tube. ■ Fix bracket with screws. ■ Place the camera on to 1/4” tripod bolt and tighten hinge screw. -
Page 12: Specifications
Specifications Screen 2.0" TFT Screen Lens Angle 58° Mode Photo/ Video / Photo Video Video Resolution 1080P, 720P, VGA Photo Resolution 16MP, 14MP, 12MP, 10MP, 8MP, 5MP, 3MP, 2MP, 1MP Triggering Time 0.5S Recovery Time LED Type No Glow LEDs, 850nm... - Page 13 Temperature Detection Support Speaker/Microphone Build-in Language English / Deutsch /Francais /Italiano /Spanish /Japanese Issue Root Cause Solution Low power / incorrect battery Replace battery with adequate model power and correct model Incorrect battery installation Correctly install battery according to instructions...
- Page 14 SD card has low rate of Replace a higher speed SD cards read/write (recommende Class10 or above) SD card damaged Replace a higher speed SD cards SD card cannot SD card not formatted before Format the SD card before using...
- Page 15 Power consumption is related to the frequency of animal activities. If the animal is frequently active in front of the camera, the camera will record lots of photos or videos automatically them results in excessive power consumption. Sealing ring was ejected from...
- Page 16 The product is IP66 waterproof rating, it is FORBIDDEN to immersing in the water. Please keep the waterproof ring and waterproof ribs clean, intact, and flat. Do not disassemble the waterproof ring and waterproof ribs. If the machine has been flooded, please power off the machine immediately and dry it before restart.
Need help?
Do you have a question about the H7 and is the answer not in the manual?
Questions and answers