Attaching The Cables To The Monitoring; Connecting Cables To The Computer - Fujitsu P2410 Series Operating Manual

Getting started

Attaching the cables to the monitoring

B Series
The B-series features a VGA and DVI port with locking connectors according to the
respective standard. VGA and DVI cables compliant with the respective standards (not
included in the scope of supply, available separately) can be attached.
P Series
The P-series features a USB-C Upstream port with locking connectors as per "USB Type-C Locking
Connector Specification (Revision 1.0)". "Single Screw" and "Dual Screw USB Type-C Locking Plug"
USB-C cables (not included in the scope of supply, available separately) can be attached.
Single Screw USB Type-C Locking Plug
► Attach the cable connector to prevent the cable from accidentally being disconnected.

Connecting cables to the computer

Information on the computer connections and interfaces is contained in the
operating manual for your computer.
► Plug the data cable into the (active) monitor port on the computer.
► Plug the power connector of the monitor into a properly grounded mains outlet.
► Plug the power connector of the computer into a properly grounded mains outlet.
If your computer has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is active as standard.
All of the USB ports designated as "Downstream" and the network port
are only active while at least one of the two USB ports designated as
"Upstream" is connected to a computer.
As soon as a computer gets connected via the USB-C monitor port, the active input
signal is switched automatically to USB-C. When the USB-C connection is interrupted,
the system automatically switches back to the last active input signal.
20
Dual Screw USB Type-C Locking Plug
Fujitsu