Bosch LHN-UC15L-SIP User Manual page 11

LHN‑UC15L‑SIP | LHN‑UC15W‑SIP | AMN‑P15‑SIP
The Line-in allows you to route an external analog audio signal into the device. The Line-out
allows you to route an audio signal to an external device.
Both audio connections are analog unbalanced.
For example:
Analog audio used as Line-in
To connect the analog Audio:
1.
2.
3.
4.
Reassembling the cover
After you make all the relevant connections to the IP Horn loudspeaker, reassemble the cover.
To reassemble the cover:
1.
2.
3.
Bosch Security Systems B.V.
Line-
Source
Remove the cap on the bottom right of the cover.
Attach the cable gland (supplied) to the bottom right of the cover.
Thread the cable through the cable gland.
Connect the wires to the Audio terminal on the device (Figure 2.2, callout 3).
Fit the rubber seal on the cover. Make sure that the seal is properly placed.
Align the cover with the screw holes, with the cable glands facing downwards.
Using a T20 Torx screwdriver, tighten the four cover screws with a torque of 1.3 - 1.8 Nm.
Analog audio used as Line-out
User manual
Installation | en
Line-
Input
2023.02 | V01 | F.01U.389.835
11