Sustainable Solutions fluid Installation

Quad Siphonic Rimless
1.28/0.8 gpf (4.8/3 lpf)
Easy Height & Elongated
One Piece Toilet with
Side Lever Handle
RH Lever FT160110W-R
PLUMBER'S INSTALLATION INSTRUCTIONS. PLEASE
READ CAREFULLY BEFORE INSTALLATION.
Rough in:
It is essential for the installation of the Quad Siphonic Rimless
One Piece Toilet that the closet flange must be accurately
set out from the finished wall as detailed in Fig.1.
Working Water Pressure:
USA & Canada: Recommended working water pressure is
20-80psi (140-550Kpa).
Installation Procedure:
1- Position closet bolts into closet flange (not supplied), as
detailed in Fig.1. Make sure two closet bolts are pointing
straight up and are directly across from each other.
2- Securely attach the two closet bolts onto the closet flange
using the supplied flange lock nuts.
3- Ensure that the area around the toilet bottom is clean and
free from building material.
4- Position and firmly place the supplied wax ring onto the
trapway, as detailed in Fig.2.
5- Accurately align the toilet over the closet bolts and flange
and lower into position as detailed in Fig. 3.
6- Secure the toilet by hand tightening nuts and metal
washers onto the closet bolts through the side opening.
Apply an additional 1/2 turn with a wrench tool for final
installatioin, as detailed in Fig. 4.
7-
Cover the round holes on both sides of toilet with the
supplied square covers.
8-
It is recommended that a bead of silicone caulking is
applied fully around base of the closet bowl.
9- Remove any excess silicone caulking.
10- Connect the water supply line to toilet inlet valve
connection as detailed in Fig. 5 and check all connections
for leaks. Note: The tapered rubber seal and wing nut
assembled at the inlet valve connection end is a 3/8" hard
tube/pipe connection. Remove them if a braided toilet
supply line connector is used.
11- Install the side handle lever according to the instructions
included with the side lever.
12- Install the toilet seat according to the instructions included
with the seat.
13- Push side lever down firmly for a full flush and pull side
lever up for a reduced flush.
All measurements are subject to accepted manufacturing tolerances.
To ensure complete accuracy, please check actual product dimen-
sions before drilling for installation. The manufacturer reserves the
right to change specifications at any time without giving prior notification.
This product should be installed by a qualified plumber. Local authority,
Water Board, and Building Regulations may apply to the installation of
this product, and you should consult the appropriate bodies on these
requirements. Failure to comply may invalidate the product warranty.
Sustainable Solutions
LH Lever FT160110W
Vitreous China Dual Flush
High Efficiency (UHET)
Vancouver BC + Ferndale WA
Location of
Angle Stop
216 mm
8-1/2"
Closet Bolt
Flange
Lock
Nut
Closet Flange
Fig. 1
Water
Supply
Line
Closet Bolt
Angle Stop Valve
Closet Flange
Fig. 3
Water
Supply
Line
Angle Stop Valve
Fig. 5
Wax Ring
Fig. 2
Nut
Metal Washer
Square Cover
Fig. 4
For further information please visit our website
www.sustainablesolutions.com
Date of Issue: Oct 2022