Lincoln Electric WELD-PAK 90i FC Operator's Manual page 10

Table of Contents

Advertisement

Available languages

Available languages

WELD-PAK 90i FC
INPUT POWER CONNECTION
The machine has one input connection, the power input cable. The
power input cable is located on the rear.
The Weld-Pak 90i FC is provided with a 120V cable, 6.0ft. (1.8m)
in length, with a 15Amp 5-15P plug molded onto the cord.
The rated output of the Weld-Pak 90i FC is available when
connected to a 20A branch circuit. When connected to a branch
circuit with lower capacity, lower welding current and duty cycle
must be used.
CODE REQUIREMENTS FOR ELECTRICAL INPUT
CONNECTIONS
WARNING
This welding machine must be connected to a power source
in accordance with applicable electrical codes.
The National Electrical Code provides standards for amperage
handling capability of supply conductors based on duty cycle of
the welding source.
If there is any question about the installation meeting applicable
electrical code requirements, consult a qualified electrician.
WARNING
Do not connect the machine to an input power supply with a
rated voltage that is greater than 125 volts.
Do not remove the power cord ground prong.
EXTENSION CORD USAGE
If an extension cord is required, use one that is rated for the
application and is 3 conductor #14 AWG (2.1 mm2) or larger. The
recommended maximum lengths are 25 ft (7.5 m) if #14 AWG (2.1
mm2) is used and 50 ft (15 m) if #12 AWG (3.3 mm2) is used.
FLUX-CORED (INNERSHIELD) WELDING
The recommended electrode for the flux-cored, self-shielded
process is 0.035" (0.9 mm) diameter Lincoln Innershield
NR-211-MP on 1 lbs. (.5 kg) spools.
FIGURE 1
3
1
2
1. Adjustment for Voltage
2. Adjustment for Wire feed speed
3. Power and protection LEDs
4. Gasless Flux-Cored torch
5. Work Clamp
8
6
7
6. Power Switch
7. Power Input Cable
8. Spool cover latch
INSTALLATION
4
5

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WELD-PAK 90i FC and is the answer not in the manual?

Questions and answers

Jim
January 29, 2025

What gage extension. It’s do I need For this

1 comments:
Mr. Anderson
February 10, 2025

For the Lincoln Electric WELD-PAK 90i FC, use a 3-conductor extension cord with a minimum gauge of #14 AWG (2.1 mm²) for lengths up to 25 feet (7.5 meters). For lengths up to 50 feet (15 meters), use a #12 AWG (3.3 mm²) extension cord.

This answer is automatically generated

This manual is also suitable for:

13397

Table of Contents

Save PDF