Mitsubishi Electric 840 Series Quick Setup Manual page 2

Channel Scan for the
ANT (Antenna) Input
You must perform a channel scan to enable recep-
tion of digital channels. If you skip this step, the TV
will receive only analog channels. The scan will search
for local channels available from an antenna or direct cable
service (no cable box). Note: Direct cable service will not
include scrambled or premium channels.
1.
Power on the TV.
2.
Connect the incoming coaxial
cable to the TV's ANT input.
MENU
3.
Press MENU.
4.
Open the Setup > Channel menu. Press ENTER.
5.
Highlight Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press ENTER to add a
check.
6.
Highlight All channels. Press ENTER to add a check.
7.
Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
Important Note About High-Definition TV (HDTV)
To view high-definition (HD) pictures you must use
a high-definition programming source and suitable
cable type (e.g., HDMI or component). Examples of
high-definition sources are:
• Cable service with an HD cable box
• Direct cable service without a box
• Satellite service with an HD receiver
• Blu-ray disc player
• Over-the-air antenna
Your cable TV or satellite service provider may
charge extra for high-definition service.
The TV's Test Picture feature displays a high-
quality sample image that demonstrates the TV's
display capabilities. Press MENU and go to Picture >
Picture+ > Test Picture.
Quick Setup Guide
Setting Up Other Inputs
1.
Power on the TV and your A/V devices.
2.
Connect one device to the TV, making note of the
TV input jack.
The TV will display the New Device Found screen if
the connection type is detectable.
3.
Highlight the device type in the on-screen list and
press ENTER to add a check by the device name.
The name you select here will appear in the Input
Selection menu.
Sample
New Device
Found menu
EXIT
5.
Repeat these steps for each additional device you
want to add.
Selecting a Source to Watch
1.
Press INPUT.
Sample Input Selection menu, antenna input selected
2.
Press
3.
Press ENTER to switch to the input.
4.
Press EXIT to close the New Device
Found screen.
INPUT
and to highlight an input icon.