Wlan Internet Access Points - Nokia 5800 XpressMusic User Manual

To edit a packet data access point, open one of the access
point groups, and select an access point marked with
Follow the instructions from your service provider.
Select from the following:
Access point name — You obtain the access point name
●
from your service provider.
User name — The user name may be needed to make a
●
data connection, and is usually provided by your service
provider.
Prompt password — If you must enter the password
●
every time you log in to a server, or if you do not want to
save your password in the device, select Yes.
Password — A password may be needed to make a data
●
connection and is usually provided by your service
provider.
Authentication — Select
●
password encrypted or
encrypted when possible.
Homepage — Depending on the access point you are
●
setting up, enter the web address or the address of the
multimedia message centre.
Use access point — Select
●
want the device to ask for confirmation before the
connection using this access point is created, or
Automatically if you want the device to connect to the
destination using this access point automatically.
Select Options Advanced settings
>
following:
Network type — Select the internet protocol type to
●
transfer data to and from your device. The other settings
depend on the selected network type.
© 2009 Nokia. All rights reserved.
Secure to always send your
Normal to send your password
After confirmation
and from the
Phone IP address
●
. of your device.
DNS addresses
●
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
●
server.
Proxy port number
●
server.

WLAN internet access points

Select Menu
Destinations
on the screen.
To edit a wireless LAN (WLAN) access point, open one of the
access point groups and select an access point marked with
.
Follow the instructions from your WLAN service provider.
WLAN network name
●
Search for
if you
WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
Network status
●
displayed.
WLAN network mode
●
hoc network and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
(for IPv4 only) — Enter the IP address
— Enter the IP addresses of the primary
— Enter the address of the proxy
— Enter the port number of the proxy
Settings and Connectivity
>
Access point, and follow the instructions
>
— Select Enter manually
networks. If you select an existing network,
— Define whether the network name is
— Select Ad-hoc
>
or
to create an ad
73