Installation Of Air Storage Tanks; Installation Of Wiring - Boss Industries INFINITY 35 Product Manual

Installation of Air Storage Tanks

This rotary screw air compressor system is designed
to provide continuous volume and constant pressure
without the use of an air storage tank. Within a few
seconds of engagement, the compressor will produce
full volume and pressure needed to run corresponding
air operated equipment without waiting for air tanks
to fill.
Air storage tanks are not utilized as standard
equipment on vehicle mounted rotary screw
compressors. The installation of air storage tanks, if
not done properly, will hinder the performance of the
rotary screw compressor. Boss Industries, LLC
strongly discourages the use of an air storage tank as
standard equipment for vehicle mounted rotary screw
air compressors.
In the rare event air usage is required without
operating the vehicle, an air storage tank can be added
to your system. When adding an air storage tank, be
sure to follow all state and federal DOT regulations
regarding air storage tank usage.
Installation & Operation

Installation of Wiring

This unit is shipped from the factory with all
necessary internal wiring installed. The only
remaining wiring necessary is the wiring needed to
interface your vehicle/power source with the Boss
compressor. The unit is shipped with 1 end of a 4 pin
connector. They need to be connected as follows:
Pin A) Battery Power
Pin B) Power out to hydraulic system solenoid
through safeties
Pin C) Battery Ground
Pin D) 12VDC switched power for operation
Pin 'B' should be used to direct hydraulic flow to the
compressor. This wire can also be used with a relay
to signal the engine speed to increase if additional
hydraulic flow is required during compressor
operation. See one example below.
- 10 -
310928