Related Manuals for SUNVILLA 11 Foot Offset Umbrella
Summary of Contents for SUNVILLA 11 Foot Offset Umbrella
- Page 3 Step 2: Screw the Finia Cap (A) into the top of the Sunshade (B) . Step 3: With the unbrella base (E) completely filled with water and with the final umbrella location decided, insert the Sunshade Pole (B) into the Rotation Part (D) carefuly, it is possile two persons may be needed for this step.
- Page 4 Step 4: Secure Sunshade Pole (B) into Rotation part (D) By using Two M8* 16 Bolts (G) and Two Small Washer (F), tighten using # 6 Allen Wrench (J). Step 5: Insert the crank (C) handle into Pole Housing hole as shown below. Make sure it snaps into housing.
- Page 5 Step 6: To raise canpoy, press the button on the umbrella hand slider and lift upwards. Release the button to set canpoy into desided location. Use the crank (C) handle to open the and close canpoy. To lower canopy first, close canopy by turing crank conter colorwise , then push button on hand slider to low position.
- Page 6 Step 8: Put your hand into handle housing. Adjsut to lower position. Take out the crank and then put into the hole shown in the below picture (Part 1), rotate left and right (largest can rotate 35 degree). All position are shown below. PART 1 Limit Position Limit Position...
- Page 7 Step 9: Pull down the handle housing into the position which is easy to handle the crank, arrow to rotate the the crank, meanwhile pull down the slider until canpoy is near the stand pole. Then use the stripe to fasten the umbrella.
Need help?
Do you have a question about the 11 Foot Offset Umbrella and is the answer not in the manual?
Questions and answers