Rotate the headlight switch clockwise from the parking
lights and instrument panel lights position to the first
detent to turn the headlight switch to the AUTO position.
Rotate to the second detent to turn on headlights, parking
lights, and instrument panel lights.
The headlight switch is equipped with an AUTO and
ON detent but not an OFF detent. Headlights will be
deactivated when the headlight switch is placed in the
parking lights position. However, the Daytime Running
Lights (DRLs) will be activated along with the front and
rear marker lights. The DRLs may be deactivated when the
parking brake is engaged, or the gear selector is in the
PARK position.
NOTE:
Your vehicle is equipped with plastic headlight and fog
light (if equipped) lenses that are lighter and less
susceptible to stone breakage than glass lights.
Plastic is not as scratch resistant as glass and there-
fore different lens cleaning procedures must be
followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth.
To remove road dirt, wash with a mild soap solution
followed by rinsing.
CAUTION!
Do not use abrasive cleaning components, solvents,
steel wool or other abrasive materials to clean the
lenses.
M
L
ULTIFUNCTION
EVER
The multifunction lever is located on the left side of the
steering column.
Multifunction Lever
GETTING TO KNOW YOUR VEHICLE
D
R
L
AYTIME
UNNING
IGHTS
I
E
F
QUIPPED
The Daytime Running Lights (DRLs) come on whenever the
engine is running, and the low beams are not on. The
lights will remain on until the ignition is placed in the OFF
or ON/RUN position, the parking brake is engaged, or the
gear selector is in the PARK position. The low beams must
be used for normal nighttime driving.
NOTE:
If allowed by law in the country in which the vehicle was
purchased the Daytime Running Lights can be turned
on and off using the Uconnect system
On some vehicles, the Daytime Running Lights may
deactivate, or reduce intensity, on one side of the
vehicle (when a turn signal is activated on that side), or
on both sides of the vehicle (when the hazard warning
lights are activated).
H
/L
B
S
IGH
OW
EAM
WITCH
Push the multifunction lever toward the instrument panel
to switch the headlights to high beams. Pulling the
multifunction back toward the steering wheel will turn the
low beams back on, or shut the high beams off.
49
(DRL
) —
S
page 168.
Ú
Need help?
Do you have a question about the GRAND CHEROKEE 2023 and is the answer not in the manual?
Questions and answers
Can't shift transmission out of park
The 2023 Jeep Grand Cherokee may not shift out of PARK due to the transmission locking mechanism, which can make it difficult to move the gear selector. Additionally, the Brake/Transmission Shift Interlock (BTSI) system holds the transmission gear selector in place. To shift out of PARK, the driver must firmly press the brake pedal. If the vehicle is on a grade, turning the front wheels toward the curb (downhill) or away from the curb (uphill) can help prevent movement.
This answer is automatically generated