Sealey MIG/T15 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear a
instruction welding
manual mask
Welding sparks Electromagnetic
can cause fields can cause
explosions pacemaker
or fire malfunction
1. SAFETY
■ BEFORE USE, ALWAYS ENSURE THAT YOU ARE FAMILIAR WITH THE SAFETY WARNINGS AND INSTRUCTIONS FOR
THE WELDER TO WHICH THIS TORCH IS TO BE FITTED.
DO NOT exceed the rated current of the torch.
8
DO NOT use if any part of the torch, cable or connector is damaged in any way. Use only genuine Sealey replacement parts for
8
repairs.
DO NOT allow the cable to come into contact with any sharp or hot items.
8
Always use the correct personal protective equipment as specified in the welder instructions.
9
2. INTRODUCTION
Professional torches with contoured grip and heat-proof cable. Euro connection enables quick and simple plug connection to welder.
No wiring means torch can be disconnected and stored safely. Made in Europe.
3. SPECIFICATION
Model No.
Rated Current CO
2
Rated Current M21
Wire diameter
Gas Flow
Length
Torch Type
4. OPERATION
WARNING: Disconnect from power source while setting up.
‰
NOTE: The type and quantity of the shielding gas quantity depends on the welding task and the gas nozzle geometry. Make all
shielding gas connections gas-tight.
NOTE: As the MIG/MAG welding torch is part of an integrated welding system, the operating instructions and safety guidelines of the
of the welding power source, must be observed during operation.
4.1. Using a standard welding torch, the two-position mode of the trigger can be activated (press to weld, release to stop welding).
4.2. Further operating modes and handle modules depend on the corresponding welding power source.
4.3. To connect the torch to the power source:
4.3.1. Remove the tip adaptor and contact tip.
4.3.2. Inch the wire from the exit of the wire guide on the feed unit as Figure 1. Ensure that it does not short out on any machine panels.
4.3.3. Carefully slide the electrode wire into the torch liner and slowly locate the torch gun plug body into the feed unit central connector
and tighten the gun plug nut as Figure 2.
4.3.4. Keeping the torch as straight as possible, use the power source inch facility or torch trigger to feed the electrode wire 50mm from the
end of the liner conduit.
4.3.5. O nce the electrode wire has stopped, refit the tip adaptor, diffuser, contact tip and gas nozzle.
© Jack Sealey Limited
MIG TORCHES WITH 3M EURO CONNECTOR
MB15 , MB25
MODEL NO:
Warning!
Wear protective
Electricity
gloves
shock hazard
MIG/T15 MIG/T25
140A 140A
160A 184A
0.6 - 1.0mm 0.8 - 1.2mm
10 - 18 l/m 10 - 18 l/m
3m 3m
MB15 MB25
Original Language Version
MIG/T15.V2, MI/T25.V2
Warning! Caution
Keep away required
from rain
fig.1
Arc rays can Electric shock
burn eyes and from welding
injure skin electrodes can
MIG/T15.V2, MIG/T25.V2 Issue 1 31/10/22
Breathing
welding fumes
can be
hazardous to
your health
fig.2