kbice FDFM1JA01 Quick Start Manual

KBice Self-Dispensing Nugget Ice Maker Dispenser
QuickStart Guide —
INSTALLATION
Clearance Requirements
CAUTION
This unit is designed for household countertop use
only.
Never block the air vent on the left side.
The unit operates in an area with a maximum
ambient temperature of 85°F. Therefore, the warmer
ambient temperature will result in reduced ice
capacity and quality.
Never operate this unit in direct sunlight.
Allow for a minimum clearance of 4 inches on both
left and right sides, 2 inches on the back, and ½ on
the top to ensure the proper functionality of the unit.
Scan here for instructional video:
FDFM1JA01
1. Display Panel
2. Ice Dispense Point
3. Water Fill Port
4. Air Vent
5. Drip Tray
6. Power Cord
7. Drain Tube Plugs/Holder
8. Funnel
(The funnel is located inside the reservoir)
Call or Text "Help" 800.433.9938 | info@kbgoodice.com | www.kbgoodice.com
Electrical Requirements
DANGER
This unit requires that you connect only to a
GFCI protected receptacle.
Strongly advised that you do not use an adapter
to connect this unit because of safety hazards.
A dedicated 120V, 60Hz, 15A fused, grounded
electrical supply is required.
Water Requirements
TDS
This unit requires purified or distilled water,
which significantly improves the ice quality
and ice making performance. Water with a
TDS or hardness of <100 PPM is also
acceptable. Water with over >100 PPM will
cause the unit to go into "Clean" Mode
frequently and not produce ice.