Sunbeam SWM6000 Series - Filter Free Warm Mist Humidifier Instruction Leaflet
![]()
INTRODUCTION
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before using the appliance.
- To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet.
- Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs or near heat registers.
- DO NOT place humidifier near heat sources such as stoves, radiators, and heaters. DO locate your humidifier on an inside wall near an electrical outlet. The humidifier should be at least 4 inches (10 cm) away from the wall for best results.
- NEVER place humidifier in an area where it is accessible to children. NEVER use humidifier in a closed room, particularly where a child may be sleeping, resting, or playing (a closed room may result in excessive humidity).
![]()
Do not attempt to refill humidifier without first unplugging the unit from its electrical outlet. Failure to heed this warning may cause personal injury. Be sure to unplug the unit by pulling on the plug and not the cord. - Never place anything over moisture outlet when the unit is running.
- NEVER drop or insert any object into any openings. DO NOT place hands, face or body directly over or near Moisture Outlet while unit is in operation. DO NOT cover Moisture Outlet while the unit is operating.
- DO NOT operate any appliance with a damaged cord or plug, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair.
- Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold the manufacturer may cause hazards.
- DO NOT use outdoors.
- Always place humidifier on a firm, flat, level surface. A waterproof mat or pad is recommended for use under the humidifier. NEVER place it on a rug or carpet, or on a finished floor that may be damaged by exposure to water or moisture.
- DO NOT allow the Moisture Outlet to directly face the wall. Moisture could cause damage, particularly to wall paper.
- Humidifier should be unplugged when not in use.
- NEVER tilt, move, or attempt to empty unit while it is operating. Shut off and unplug before removing the water tank and moving the unit. If you have a warm mist humidifier, DO NOT attempt to remove the water tank within 15 minutes after the humidifier is turned off and unplugged. Serious injury may result.
- This humidifier requires daily and weekly maintenance to operate appropriately. Refer to daily and weekly cleaning procedures. Use only cleaners and additives recommended by the manufacturer. Never use gasoline, glass cleaner, furniture polish, paint thinner, or other household solvents to clean any part of the humidifier.
- Excessive humidity in a room can cause water condensation on windows and some furniture. If this happens, turn the humidifier OFF.
- Do not use humidifier in an area where humidity level is in excess of 50%. Use a hygrometer, available at your local retailer or through the manufacturer, to measure the humidity.
- DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
- Never place housing under water flow, or immerse in liquids.
- DO NOT plug in the cord with wet hands, electric shock could result.
- DO NOT pour water in any openings other than the water tank.
- If you have a warm mist humidifier, allow unit to cool before refilling water tank or maintenance as the heater bulb is hot.
- To prevent damage to surfaces, do not place humidifier under overhanging surfaces.
- NEVER operate unit without water in the tank.
- Do not move unit after it has been used until unit cools completely.
- Use both hands when carrying full tank of water.
- Failure to clean device per the cleaning instructions in the instruction book may result in overheating or fire.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
![]()
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY.
FEATURES - OPERATIONS
NOTE:
- This is an electrical appliance and requires attention when in use.
- If moisture forms on the walls or windows of the room, turn off the humidifier. The room already has plenty of humidity and additional moisture may cause damage.
- DO NOT block air inlet or outlet
- Keep unit away from surfaces that can be damaged by water and/or heat (such as wood floors).
- Place mat underneath the unit during use.
- Do not place the humidifier on carpet. The heat sink underneath the humidifier might cause the carpet to be discolored and may cause overheating of the unit.
Cord and Plug Installation Safety Instructions:
The length of cord used on this appliance was selected to reduce the hazards of becoming tangled in, or tripping over a longer cord. If a longer cord is necessary an approved extension cord may be used. The electrical rating of the extension cord must be equal to or greater than the rating of the humidifier (refer to the rating information placed on the humidifier). Care must be taken to arrange the extension cord so that it will not drape over the countertop or tabletop where it can be pulled on by children or accidentally tripped over.
HOW WARM MIST WORKS
Your Sunbeam® Warm Mist humidifier is designed to allow the proper amount of water to flow out of the tank. Air is drawn in through the grill openings located in the back of the unit and mixed with steam in the misting chamber. The warm mist is then dispersed out of the top of the misting chamber through the outlet grill and into the room.
NOTE: A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40%-50%.
PRE-OPERATING INSTRUCTIONS
- Be sure the humidifier is switched off.
- Select a location for your humidifier, on a flat level surface about 4 inches (10 cm) away from the wall. DO NOT place the humidifier on a finished floor or near furniture, which can be damaged by too much moisture or water. Place on a moisture resistant surface.
- Remove the tank from the main housing.
- This humidifier holds about 0.9 gallons of water in the tank and humidifier base. The humidifier will produce up to 2.5 gallons of water over a 24-hour time period.
- Make sure the safety lock is rotated completely to the locked position. Place tank back on to the base. The tank will immediately begin to empty into the base.
- Plug the humidifier into a 120V electrical outlet.
OPERATING INSTRUCTIONS
- To turn the unit on, switch the knob to the High (2) position. High will produce the maximum moisture and Low will produce the longest run time and quieter performance. The power light (
) will be on. It is normal for the humidifier to take 10 minutes to boil the water and begin to mist. - To turn the unit to low, switch the knob to the LOW (1) position. To turn the unit off, switch the knob to Off (
). - The Medicine cup is located on the top of the mist chamber. To use, pour designated humidifier medication into the cup. DO NOT add medication to the water tank. DO NOT add medication to the medicine cup when the unit is already operating.
RESET PROCEDURE
NOTE: When the water in the tank is empty and the water in the heating chamber is almost empty, the Automatic Shut Off will activate. The RESET light (
) will illuminate and the unit will not operate again until you refill the water tank and reset the humidifier as outlined below.
- Turn the power knob to Off (
). - Unplug the unit.
- Remove and refill the water tank, being sure to follow the Daily Maintenance instructions. Replace the tank onto the base.
- Allow 15 minutes for the Automatic shut off to reset.
- After the 15 minutes, plug in the unit and turn the Power knob to High (2). The Reset light (
) should now be off. In about 10 minutes the unit will begin to produce moisture.
If the reset light (
) is still on at this point, and the unit does not begin to produce moisture within a few minutes, then repeat Steps 1-5.
![]()
If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank and base to prevent algae or bacterial growth.
![Sunbeam - SWM6000 Series - OVERVIEW OVERVIEW]()
- HUMIDIFIER TANK
- HUMIDIFIER HOUSING
- TANK HANDLE
- CONTROL KNOB
- HUMIDIFIER BASE
- MEDICINE CUP
CLEANING AND MAINTENANCE INSTRUCTIONS
The following maintenance procedures must be routinely followed in order to ensure proper, efficient operation of your humidifier. The unit WILL NOT WORK CORRECTLY if it is not cleaned properly.
When the unit is in use, daily and weekly maintenance is recommended. Regular weekly cleaning prevents scale buildup on the heating element and base. It also prevents micro-organisms from growing on the base. This ensures that maximum efficiency will be achieved.
We cannot over-emphasize how essential proper cleaning is to the maintenance and continued use of your unit and to the avoidance of algae or bacteria build-up.
DAILY MAINTENANCE
Allow to cool before maintenance.
- Before cleaning, set the control to OFF (
) position and unplug the unit from the electrical outlet. - Remove the water tank then unlock the misting chamber by rotating the safety lock towards the front of the unit. Lift mist chamber from the unit's base.
- Empty water and minerals from the base and place in the top rack of the dishwasher. This will remove any sediment and dirt that has accumulated in the base.
NOTE: It is imperative that the base is cleaned properly. The base is dishwasher safe (top rack ONLY) for easy cleaning. - Wipe the heating element clean with a soft cloth after it has had a chance to cool.
- Replace misting chamber and engage safety lock. The Electronic Thermal Control Heating element is lined with a coating that is designed to provide the easiest cleaning and prolong the operating efficiency of the humidifier. DO NOT use any metal or hard objects to clean the Heating Element. Never use detergents, gasoline, kerosene, glass cleaner, furniture polish, paint thinner or other household solvents to clean any part of the humidifier.
WEEKLY MAINTENANCE
Remove Scale: Allow to cool before maintenance.
- Repeat steps 1-5 in the Daily Maintenance section.
- Clean the tray by partially filling the base with one 8-oz cup of undiluted white vinegar. Let solution stand 20 minutes, cleaning all interior surfaces with a soft brush. Dampen a cloth with undiluted white vinegar and wipe out entire base to remove scale.
- Rinse with clean warm water to remove scale and the white vinegar solution before beginning to disinfect the tank.
- Wipe the heating element clean with a soft cloth after it has had chance to cool.
Disinfect tank:
- Fill tank with 1/2 teaspoon of chlorine bleach and 1/2 gallon (1.9L) of water.
- Let the solution stand for 20 minutes, swishing every few minutes. Wet all surfaces.
- Empty the tank after 20 minutes, and rinse well with water until the bleach smell is gone. Dry with a clean cloth or paper towel.
- Refill the water tank with cool water; replace the housing and water tank. Repeat ALL Operating Instructions.
STORAGE INSTRUCTIONS
When not using your humidifier for an extended period of time:
- Clean, rinse and thoroughly dry the humidifier as directed in weekly maintenance. DO NOT leave any water in the unit when storing. Leaving water in the unit may render the unit inoperable for the following season.
- Place the humidifier in the original carton and store in a cool, dry place.
- Wait for the heating element to cool completely, and then clean the heating element with a damp soft cloth.
- Remove the tank cap. Do not store with the tank capin place.
For inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility.
REPLACEMENT ACCESSORIES
To order the replacement accessories you can do any of the following:
- Visit your local retailer
- Go to www.sunbeam.ca
- Call consumer service at 1-888-264-9669
If you have any questions regarding your product or would like to learn more about other Sunbeam® products, please contact our Consumer Service Department at 1-888-264-9669 or visit our website at www.sunbeam.ca.
TROUBLESHOOTING
TROUBLESHOOTING |
TROUBLE | PROBABLE CAUSE | SOLUTION |
Unit does not turn on. | Not plugged in. Outlet not functioning. | Plug in unit. Have outlet replaced by a licensed electrician. |
Refill/Reset light illuminated. | Water Tank Empty. Unit not reset after refill. Scale buildup on heating element. | Refill Tank. Follow manual for Reset Instructions. Remove scale from heating element. |
Mist output minimal to none. * Scale buildup on heating element. | Humidifier is not warmed up yet. | Remove scale from heating element. Allow 10 minutes for the humidifier to warm up. |
Water Leaks from tank. | Tank rubber ring is missing. Cap not tight enough. Tank water is Hot. | Remove tank cap and replace or reposition ring. Tighten the cap. Fill with cool water only. |
Crack in Tank. | Hot water will cause tank to pressurize. Tanks will crack if hit or dropped. | Fill with cool water only. Handle tank with Care. |
Film on tank. | Mineral deposits. | Clean/disinfect tank as instructed in weekly cleaning instructions |
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Sunbeam SWM6000 Series - Filter Free Warm Mist Humidifier Instruction Leaflet
Need help?
Do you have a question about the SWM6000 Series and is the answer not in the manual?
Questions and answers