Dell Latitude 7230 Service Manual page 86

Table 10. System setup options—Connection menu (continued)
Connection
WLAN
Bluetooth
Contactless smartcard/NFC
Enable UEFI Network Stack
Wireless Radio Control
Control WLAN radio
Control WWAN radio
HTTPs Boot Feature
HTTPs Boot
HTTPs Boot Mode
Antenna Switch
WLAN Antenna
WWAN Antenna
GPS Antenna
Table 11. System setup options—Power menu
Power
Battery 1 configuration
Battery 2 configuration
86 BIOS setup
By default, the Bus Mode PCIe option is enabled.
Enable or disable the internal WLAN device.
By default, the option enabled.
Enable or disable the internal Bluetooth device
By default, the option enabled.
Enable or disable the internal Contactless smartcard/NFC device
By default, the option enabled.
Enable or disable UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Auto Enabled option is selected.
Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WLAN).
By default, the option is disabled.
Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WWAN).
By default, the option is disabled.
Enable or disable the HTTPs Boot feature.
By default, the Auto Mode option is enabled.
With Auto Mode, the HTTPs Boot extracts Boot URL from the DHCP. With
Manual Mode, the HTTPs Boot reads Boot URL from the user-provided data.
By default, the Auto Mode option is enabled.
Enable or disable the Dock Antenna or System Antenna option.
By default, the Dock Antenna option is enabled.
Enable or disable the Dock Antenna or System Antenna option.
By default, the Dock Antenna option is enabled.
Enable or disable the Dock Antenna or System Antenna option.
By default, the Dock Antenna option is enabled.
Enables the system to run on battery during peak power usage hours. Use the
table Custom Charge Start and Custom Charge Stop, to prevent AC power
usage between certain times of each day.
By default, the Adaptive option is enabled.
Enables the system to run on battery during peak power usage hours. Use the
table Custom Charge Start and Custom Charge Stop, to prevent AC power
usage between certain times of each day.
By default, the Adaptive option is enabled.