Equipment Delivery And Handling; Receipt Of Shipment; Storage; Related Publications - Siemens 353 User Manual

Multi-purpose training panel

Hide thumbs Also See for 353:

Table of Contents

Introduction

1.4 EQUIPMENT DELIVERY AND HANDLING

Prior to shipment, each Training Panel is fully tested and inspected to ensure proper operation. It is then packaged

for shipment.

Inspect each carton at the time of delivery for possible external damage. Any visible damage should be immediately

recorded on the carrier's copy of the delivery slip.

Carefully unpack each carton and check the contents against the enclosed packing list. Inspect each item for any

hidden damage that may or may not have been accompanied by exterior carton damage.

If it is found that some items have been damaged or are missing, notify the Process Instrumentation Division of

Siemens Energy and Automation immediately and provide full details. In addition, damages must be reported to the

carrier with a request for their on-site inspection of the damaged item and its shipping carton.

If a Training Panel with an installed controller is to be stored for a period or moved to another location or site,

review the environmental specifications in the Model Designation and Specifications section of UM353-1.

Refer to the following publications for information on the Model 353, including configuration and calibration

instructions, function block (FB) information, circuit board descriptions, troubleshooting procedures, and

instructions for operating the display assembly.

•

User's Manual, Model 353 Process Automation Controller, UM353-1, Rev. 9 or later

•

Local Instrument Link Installation And Service Instruction, SD15492

Current revisions of technical literature can be obtained by visiting the Siemens Energy & Automation, Process

Industries Division Web site at www.sea.siemens.com/ia/. These publications are in Portable Document Format

(PDF) and are available for downloading.

1-4

UM353TP-1

April 2002

Table of Contents