Toshiba MP-4003 Service Manual page 3

GENERAL PRECAUTIONS FOR INSTALLATION/SERVICE/
MAINTENANCE FOR LARGE CAPACITY FEEDER MP-4003
1. When installing the Large Capacity Feeder MP-4003 to the Copier, be sure to follow the instructions
described in the "Unpacking/Set-Up Procedure for the MP-4003" booklet which comes with each
unit of the MP-4003.
2. Installed only by an authorized/qualified person.
3. When transporting/installing the MP-4003, employ two persons. The MP-4003 is fairly heavy and
weights approximately 40 kg (89 lb), therefore pay full attention when handling it.
4. Before starting installation, servicing or maintenance work, be sure to turn off and unplug the
copier first.
5. Supplied with power from the copier, requiring no additional power source.
6. Grounded to the specified positions on the machine frame.
7. When serving or maintaining, be careful about the rotating or operating sections such as gears,
pulleys, sprockets, cams, belts, etc.
8. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise
noted in this manual or other related documents. Be careful not to reassemble small parts such as
screws, washers, pins, E-rings, toothed washers to the wrong places.
9. Basically, the machine should not be operated with any parts removed or disassembled.
10. Delicate parts for preventing safety hazard problems (such as thermofuses, door switches sensors,
etc. if any) should be handled/installed/adjusted correctly.
11. During servicing or maintenance work, be sure to check the nameplate and other cautionary labels (if
any) to see if they are clean and firmly stuck. If not, take appropriate actions.
12. Use suitable measuring instruments and tools.
13. The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband,
because the ICs on it may be damaged due to static electricity.
Caution: Before using the wrist band, pull out the power cord plug of the copier and make sure that
there is no uninsulated objects in the vicinity.
14. For the recovery and disposal of used the large capacity feeder, consumable parts, packing materials,
used batteries, and RAM-ICs including litium batteries, it is recommended that the relevant local
regulations/rules.