Quick Start Guide; Printer Preparation - Z Corporation ZPRINTER 310 PLUS Hardware Manual

ZPrinter 310 Plus Hardware Manual
®
2

Quick Start Guide

This chapter provides an overview of the setup, part removal, and post-processing steps required to com-
plete a print. For a detailed step-by-step guide to printer setup, please refer to the following sections:
• "Prepare the 3D Printer" on page 21
• "Setup The Build In ZPrint®" on page 29
• "Post-Processing" on page 33.
For additional information on post-processing techniques visit the Z Corp. 3DP User Web site at
zcentral.zcorp.com.

2.1 Printer Preparation

zcentral.zcorp.com
2/11/09
1. Fill the feed box with powder. Recycle any
powder in the overflow bin or add fresh pow-
der as needed. (See Section 4.2.)
2. Spread powder over the build area and use
the tamper to gently compress the powder.
(See Section 4.2.2.) Vacuum any excess
powder from the top deck.
3. Clean and wipe the squeegees and parking
cap on the Service Station with distilled water.
(See Section 4.2.6.)
9
Quick Start Guide
All Rights Reserved