CallPass XT-2150 User Manual
  1. Manuals
  2. Brands
  3. CallPass Manuals
  4. GPS
  5. XT-2150
  6. User manual

CallPass XT-2150 User Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

XT-2150 User Manual
Last Modified on 12/23/2015 10:05 pm EST

Installation

Wiring Cable Identifier

Red cable – Power supply (12V)
Black cable – Ground
White cable – Ignition Sense

Connect the GPS Tracker

Connect the cables as described in section "Wiring Cable Identifier". After the unit is
powered, make sure that the blue status LED is blinking at at the rate of once every 3
seconds. When first powered up, it will blink at the rate of once every second and within 1-2
minutes, it will blink at the rate of once every 3 seconds. This indicates that it has an
available connection with the cellular network. Final installation should be done only
after the blue led blinks at the rate of once every 3 seconds

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XT-2150 and is the answer not in the manual?

Questions and answers

Related Manuals for CallPass XT-2150

Summary of Contents for CallPass XT-2150

  • Page 1 XT-2150 User Manual Last Modified on 12/23/2015 10:05 pm EST Installation Wiring Cable Identifier Red cable – Power supply (12V) Black cable – Ground White cable – Ignition Sense Connect the GPS Tracker Connect the cables as described in section “Wiring Cable Identifier”. After the unit is powered, make sure that the blue status LED is blinking at at the rate of once every 3 seconds.
  • Page 2 GPS Tracker Position - make sure that the label is facing the right direction (e.g. if the label on the unit says, “Label side down”, then the unit should be installed so that the Label side faces down - GPS unit needs access to GPS signals, so make sure that the install position provides this access Additional Check (Optional) Connect the white cable (ignition sense) to the power supply for a few minutes.
  • Page 3 Log Into Your Account Your login details will be mailed to you. Using the account login and password, log on to your account. Once the blue status LED is blinking once every three seconds, the device will shortly start transmitting information to the host server (it transmits once every minute when vehicle is running and every 2 hours when not running) and you can see all the logged information.

Table of Contents

Save PDF