Table of Contents
Advertisement
Holding the ejector levers of the MCP-X1 with both hands, pull the ejector levers outward, and
2.
gently pull the MCP-X1 out of the slot along the slide rails.
Figure 39 Pulling the MCP-X1 out of the slot
If you do not install a new MPU in the slot, install a blank panel. To install a new MPU, see
3.
"Installing an
Replacing a FIP module
CAUTION:
When the RUN LED of the FIP module is flashing fast, do not unplug the FIP module.
To replace a FIP module, for example, a FIP-210:
Determine the FIP module to be removed. This section uses the FIP module in slot 3 as an
1.
example.
Use a Philips screwdriver to loosen the captive screws of the FIP module to be removed, until
2.
all spring pressure is released.
Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward,
3.
and gently pull the FIP module out of the slot along the slide rails, as shown in
MPU."
49
Figure
40.
Advertisement
Table of Contents
