Trevi HE 3368 T2 User Manual page 17

HE 3368T2
7 FIRST TIME INSTALLATION
After all connections have been make sure the unit is connected to the Main power. Press power button to switch
On the unit.
If you are using the unit for the first time or have restored the unit to factory default, the installation guide menu
will appear on your TV screen.
To navigate the menus, use the navigation keys
button to exit.
 OSD LANGUAGE: press
4
COUNTRY: press

4
 FTA ONLY: press
CHANNEL SEARCH: press

Once channel tuning is complete, you can start watching TV programs.
You can finish scanning for digital channels by pressing the EXIT button.
Note: At the end of the digital terrestrial channel scan, the same channel with different frequencies
in conflict of LCN numbering may be displayed. Select the frequency to assign the LCN number and
press the OK button.
8 DIGITAL TERRESTRIAL TELEVISION (DTV)
To navigate the menus, use the navigation keys
to exit the menu items. Press the OK button to confirm the selection. Press the EXIT button to exit the menu.
8.1 BASIC OPERATION
8.1.1 AUTO SEARCH
This option will automatically search for channels and save them once the scanning is complete. All previously
saved channels and settings will be deleted.
Press MENU button to enter the main menu;

4
 Press keys and select SEARCH;

 Press keys and select AUTO SEARCH;
 Press OK button to start automatic channel scan.
To cancel channel search, press EXIT. Any channels that have been found will be saved.
Note: If the TV displays "NO SIGNAL" message, it means that it is not receiving any TV signal, so you
have to check aerial cable and connections.
8.1.2 MANUAL SEARCH
This option allows you to scan for new channels without deleting previously saved channels and settings.
 Press MENU button to enter the main menu;
4
 Press keys and select SEARCH;

Press keys to select MANUAL SEARCH and press OK or

4
 Press keys to select the channel frequency;

Press keys to select START and press OK button to start searching channels.

If a channel is found it is saved and added to the channels list. If channels can not be found during searching
the unit will exit automatically.
Note: If the message "NO SIGNAL" appears when selecting the channel, it means that no signal is
transmitted on that channel.
8.1.3 LCN FUNCTION
This decoder is equipped with the Logical Channel Number (LCN) function which is a national standard that
assigns numbers to the same channels throughout the country where you are scanning.
This function is enabled by default.
If due to the antenna signal the channel numbering does not comply with the national standard, or you want to
change the channel numbering to your liking, you must disable this function and move the channels as described
above.
 Press MENU button to enter the main menu;
4
Press keys to select PROGRAM;


Press keys to select LCN;

4
 Press keys to set the LCN to OFF.

4
key to select a language.
key to select your country of residence.
key to scan only free channels (FTA - Free to Air) or all channels (ALL).
4
or OK key to begin Automatic channel search.
4

and , press OK to confirm the selection or press the EXIT
 
, and , press the OK key to enter and the EXIT key
4
, the channel search screen will appear;
ENGLISH
17