Safety Warnings This locations such as staff kitchen areas in shops, offices and environments, farmhouses, by clients in hotels, motels and other residential type environments; bed and breakfast the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons to avoid a hazard.
Page 4
FOR EN standard : This appliance can be used by children aged from 8 years and above and persons with reduce physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Page 5
a lot the users must observe refrigerator. Firmly, grasp the plug and pull it directly out from the socket. Use a dedicated power socket. The power socket should Ensure that the manufacturer recommends them.
Page 6
circuit. Maintenance In order to avoid danger, a damaged power cord must be replaced by the manufacturer, its maintenance department, or related professionals. The gaps between refrigerator doors and between doors and refrigerator body are small. Do not put your hand in these Do not pick up food running;...
Page 7
Do not store beer, beverage or other fluid contained in bottles or enclosed containers in the refrigerator’s freezing chamber, otherwise the bottles or enclosed con ta in ers may crack due to freezing and cause damages. below the cold end of the range of temperatures for which the refrigerating appliance is designed. Carbonated drinks should not be stored in food freezer compartments or cabinets or in low- temperature compartments or cabinets.
Page 8
Preper Use of the Refrigerator Keep away from heat and avoid direct sunlight. To prevent rust or reduction of the insulating effect, do not place the refrigerator in damp or watery places. damp to be splashed easily refrigerator’s eIectricaI insuIation properties. should The refrigerator’s top space should be greater than 30cm, and the refrigerator should be placed against a wall with a free distance of more than 10cm...
Page 10
1 Unplug your refrigerator and remove all food from the door shelves. Fix the door by tape. 2 Remove the left cover plate and the right top hinge cover, then unscrew the screws and remove the right top hinge. Keep the screws to reus Right top hinge cover Left cover plate 4 Unscrew the screws of the middle hinge, remove the hinge, then lift the...
Page 11
7 Dismantle the sleeves from the top right of doors and hole cap from top left of doors, 8 Remove the refrigerator door stopper and install it on the other side of the door. sleeves self-locking stopper sleeves hole cap stopper Put down the refrigerator door bottom hinge vertically, take out the the middle hinge of the other side from the accessory bag then assemble the middle hinge on...
Page 12
10 Put down the freezer door on the middle hinge vertically, then take out the top hinge and cover of or the side from accessory bag, assemble top hinge, hinge cover and hole cover. top hinge hole cover...
2 4 Changing the light Setting the refrigerator control to off does not turn off the power to the light circuit. CAUTION: Light bulb may be hot. Lamp parameter: MAX 40W 1) Unplug the refrigerator. 2) The bulb is located at the top of the compartment near the opening. 3) Replace with an appliance bulb of equal or lower wattage.
Structure and Functions (Freezing cham ber) Shelf Door tray (Refrigera ting cham ber) Storage box Shelf Door tray refrigerating chamber Hot food should not It is recommended that all food is sealed before putting into the refrigerator. Note that should...
Page 15
① ② ③ ④ ⑤ ⑥ STANDBY Temperature Hold SET-button for 3-sec Control for standby COLDEST COLD 1 Key A.Temperature setting button of refrigerator compartment Indicator light 1.setting 1 Indicator light 2.setting 2 Indicator light 3.setting 3 Indicator light 4.setting 4 Indicator light 5.setting 5 Indicator light 6.standby mode Once initially powered on,the display screen (including the key light) is on full display for 3s.
Page 16
TEMP. CONTROL COLD COLDER Turn the controls to adjust the freezer temperature. Place frozen food into the freezer as quickly as possible after purchase. Pay attention to the storage time on the food packaging instructions. The storage life of frozen foods varies Fault indication The following warnings appearing on the display indicate corresponding faults of the refrigerator.
Page 17
Dust behind the refrigerator and on the floor must be cleaned to improve the cooling effect and energy saving. Regularly check the door gasket to make sure there is no debris. Clean the door gasket with a soft cloth Turn the power off before cleaning the interior. Remove all food, drinks, shelves, drawers, etc. To clean the interior of the refrigerator, use a soft cloth or sponge with two tablespoons of baking soda and a quart of warm water.
Page 18
in the summer, food inside the appliance can be the amount of time the door opens should be reduced and no should should objects from the inside, out, fix the glass partitions, etc. with tape, and tighten the leveling feet should should should...
Troubleshooting 5 1 You may try to solve the following simple problems by yourself. If the problems cannot be solved, contact the after-sales department. -Check whether the appliance is connected to power or whether the plug is Failed operation -Check whether the voltage is too low -Check whether there is a power failure or partial circuits have tripped -Odorous food should be tightly wrapped -Check whether there is any rotten food...
TIMING AND PROCEDURE: Before Warranty service can commence, the Original Customer must contact either (i) the retailer from whom the Original Customer purchased the Product, or (ii) Element directly, in either case for problem determination and service procedures. Valid Proof of Purchase evidencing that the Product is within the Warranty Period MUST be presented by Original Customer in order to obtain the requested Warranty service.
Page 21
United States, and only applies to Product if it was purchased and serviced in the United States. The addition of equipment or features to the Product that are not manufactured or recommended by Element could affect the intended function of the Product, and therefore may void the Warranty.
Need help?
Do you have a question about the ERT18CSCW and is the answer not in the manual?
Questions and answers