Advertisement
Quick Links
Advertisement
Related Manuals for bit BANG GAMING Super Fresh SOCD Cleaner
Summary of Contents for bit BANG GAMING Super Fresh SOCD Cleaner
- Page 1 Super Fresh SOCD Cleaner www.bitbanggaming.com @BitBangGaming...
- Page 2 To fix this issue, the inputs on a hitbox must be “cleaned” and this is absolutely required to gain entrance into a tournament. The Super Fresh SOCD Cleaner both looks clean and has the following features: 1. No lag with dedicated logic gates resulting in nanoseconds of response time.
- Page 3 (Note: For more cleaning modes, please see the Magicians SOCD Cleaner.) What’s Included: (1) Super Fresh SOCD Cleaner (2) 22-18 AWG T-taps (0.250in) (1) Pair of power wires w/ 0.250in fully insulated quick disconnects pre-crimped We offer mounting hardware and cable accessories / services compatible with this product.
-
Page 4: How To Use
BUTTONS WIRED Connect the Control PCB: The Super Fresh SOCD Cleaner has a standard 5 pin JLF port (also known as a JST NH connector) commonly used in Japanese arcade controllers coming from the control board. If your arcade controller has the mating JLF plug, simply connect to this port. - Page 5 If your arcade controller has the JST XH connector, common on many arcade controllers (such as the Mayflash F500), a 5 pin control board wire harness (Part #: CONTROL-5P-WIRE-HARNESS) can be used. If you require one, this can be purchased on our website. If your arcade controller has none of these, then you will need to create your own harness.
- Page 6 Connect the Power: The Super Fresh SOCD Cleaner can use between +3.3V to +5V as its primary voltage source and connects to it with a 2 pin pluggable terminal block. NO POWER WIRED YET POWER WIRED This 2 pin pluggable terminal block comes pre-wired and pre-crimped with 0.250 inch fully insulated male quick disconnects.
- Page 7 Once the t-taps are connected, simply plug in the quick disconnects. If you plug them in the wrong way, don’t worry, the Super Fresh SOCD Cleaner will not get fried as it has a reverse polarity protection diode. Just switch the quick disconnects around and the power LED will turn on indicating power is properly applied.
-
Page 8: Troubleshooting
In the event that there is strange directional behavior, it is very likely that the stock control PCB is not mapped how the Super Fresh SOCD Cleaner assumes, which is the most common configuration. There are two ways to fix this;... - Page 9 Hori Rap V Madkatz TES Hori Rap N Madkatz TES+ Hori VLX Ettoki Omni K Lever Madkatz TE PDP Injustice Madkatz TE2 Brook UFB/WFB/Audio Madkatz TE2+ If it is desired to have the feature work across all are controller conventions with the directional LEDs then our Magicians SOCD Cleaner will need to be used instead.
Need help?
Do you have a question about the Super Fresh SOCD Cleaner and is the answer not in the manual?
Questions and answers