Rear Brake Service; Pad Removal - Polaris ACE 900 2017 Service Manual

BRAKE SYSTEM

REAR BRAKE SERVICE

PAD REMOVAL

1. Elevate and support rear of vehicle.
WARNING
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Remove the rear wheel.
3. Loosen pad adjuster screw
4. Remove and discard the two caliper mounting bolts
w
and lift caliper off the brake disc.
CAUTION
When removing caliper, be careful not to damage brake
line. Support caliper so as not to kink or bend brake
9.18
q
2-3 turns.
line.
5. Push caliper piston into the caliper bore slowly using
a C-clamp or locking pliers with pads installed.
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.
6. Push caliper mounting bracket inward and slip outer
brake pad past the edge to remove.
7. Remove the inner brake pad.
9929422 R02 - 2017-2019 ACE 900 Service Manual
NOTE
© Copyright Polaris Industries Inc.