Sealey TP51.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Remove the pump from the drill before servicing or performing any maintenance.
‰
Maintain pump in good condition (use authorised service agent). Replace/repair damaged parts. Use recommended parts, alternative
9
parts may be dangerous and will invalidate the warranty.
Keep pump clean for best and safest performance and regularly check moving parts.
9
Risk Assess use of pump near to water etc. before connecting to mains supply.
9
Remove chuck key from the drill before operating the pump.
9
Ensure there are no flammable or combustible materials near the work area.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Remove ill fitting clothes, ties, watches, rings and other loose jewellery, and contain long hair.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
Keep drill on until desired task is complete.
9
Avoid unintentional starting.
9
DO NOT hold the pump by hand.
8
Secure using bolt holes provided.
9
DO NOT use the pump for a task it is not designed to perform.
8
DO NOT allow untrained persons to operate the pump.
8
DO NOT operate the pump if damaged, or there are parts missing.
8
DO NOT use pump where there is flammable liquids, solids or gases.
8
DO NOT leave the pump operating whilst unattended.
8
DO NOT use pump if tired, under influence of alcohol, drugs or intoxicating medication.
8
When not in use switch drill off and remove the pump and store in a safe, dry, child proof area.
9
2. INTRODUCTION
Suitable for use with electric drill with output of 350W or more. Composite housing supplied with two 1/2" quick release couplings. Delivers up to
1200L/hr of fluid at 3000rpm. Suitable for water, organic solvents, motor oil, heating oil, insecticides, pesticides, liquid fertilizers and other non-
aggressive liquids.
3. SPECIFICATION
Model No.: ............................................................... TP51.V2
Suction Head: ................................................................... 3m
fig 1
Quick Release
Adaptor
© Jack Sealey Limited
DRILL POWERED WATER PUMP
MODEL NO:
Wear
Wear eye
protective protection
gloves
Original Language Version
TP51.V2
TP51.V2 Issue 1 25/08/22