Service Mode List - Pioneer DVR-RT400-S Service Manual

1

6.3 SERVICE MODE LIST

This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily.
To enter to the SERVICE MODE function, press and hold both buttons simultaneously on the main unit or on the main unit
A
and on the remote control for more than a standard time in the appropriate condition. (See below chart.)
In case of the main unit and remote control, press the remote control buttons first, then press the main unit buttons.
Set
Set Key
Condition
VCR mode CH UP
Power On CH UP
B
VCR mode
CH UP
(Playback)
VCR mode CH UP
VCR mode
VCR/DVD
(Playback)
Power On CH DOWN
C
Power Off CH DOWN
Set
Set Key
Condition
DVD mode
STOP
D (STOP)
DVD mode
STOP
(No sisc)
DVD mode
STOP
(No sisc)
DVD mode
STOP
(No sisc)
DVD mode STOP
(STOP)
E
DVD mode
STOP
(DVD Play
back)
F
78
1
2
Standard
Set Key
Time
PLAY/REC total hours are displayed on the TV Monitor. Refer to the "6.4
FF 2 sec. CONFIRMATION OF HOURS USED".
Initialization of the factory on VCR.
PLAY 2 sec.
Note: If you set a factory initialization, the memories are reset such as the clock
Adjusting of the Tracking to the center position.
CH DOWN 2 sec. Note: Also can be adjusted by pressing the ATR button for more than 2
The BOT, EOT, and the Reel Sensor do not work and the VCR deck can be
REC 2 sec.
operated without a cassette tape.
Refer to the "PREPARATION FOR SERVICING" of section 6.1.
Adjust the PG SHIFTER automatically.
REC 2 sec.
Refer to the "6.7 ELECTRICAL ADJUSTMENTS".
Information screen displayed on the TV Monitor.
VCR/DVD 2 sec.
Refer to the "6.8 WHEN REPLACING NEW DVD LOADER".
VCR operation mode at no connection of DVD.
POWER 2 sec. Refer to the "PREPARATION FOR SERVICING" of section 6.1.
Note: Although the DVD is connected, the DVD mode cannot be selected.
Remocon Standard
Key Time
Tray cannot be opened. Refer to the "7.7 TRAY LOCK".
0 2 sec. Note: No indications on the screen when the Tray Lock is setting.
DVD Write mode.
2 2 sec.
Refer to the "7.1 RE-WRITE FOR DVD FIRMWARE".
DVD side EEPROM initial setting.
6 2 sec.
Refer to the "6.9 WHEN REPLACING EEPROM (MEMORY) IC".
Releasing of PARENTAL LOCK.
7 2 sec.
Refer to the "7.6 PARENTAL CONTROL-RATING LEVEL".
8 2 sec. Region setting.
Refer to the "6.8 WHEN REPLACING NEW DVD LOADER".
9 2 sec. Measure ment of Error Rate.
Refer to the "7.2 Measure ment of Error Rate".
DVR-RT400-S
2
3
Operations
setting, the channel setting, and PLAY/REC total hours.
seconds during PLAY.
Operations
The function will only work without the setting of DVD disc at DVD mode.
3
4
4