Sony FDR-X3000 Service Manual page 17

3-2. NOTES ON REPLACING THE LENS DEVICE
When replacing the lens device, read the QR code (TEBURE Data) that is pasted on the QR seal of the protection cap for the repairing lens device.
The read out data is used for adjustment after replacement is completed. After replacing the lens device, execute "Lens Data Carry for Shake
Cancelling" on the Adjust manual to write the extracted TEBURE data.
Also, The QR seal is pasted to upper side of the lens device. Peel off the QR seal, and then paste it on the flexible board.
Note: Use this QR code, if you cannot extract the TEBURE data from the SY board.
Peel off.
QR seal
Do not hold the following parts of the lens block (LSV-1860A).
Lens
FDR-X3000/X3000R/HDR-AS300/AS300R
QR seal
Paste on the
flexible board.
Bend of
the Flexible Board
QR seal
CM-1019 Board
3-2