Sealey POWER PRODUCTS AP1010.V2 Instructions

Model Nos:
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1 GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.
F
Locate bench in a suitable working area.
!
Keep the work area clean, uncluttered and ensure there is adequate lighting.
!
WARNING! Use bench on level and solid ground, preferably concrete. Avoid tarmacadam since the bench may sink into the surface.
F
Keep the bench clean and tidy in accordance with good workshop practice.
!
Keep children and unauthorised persons away from the working area.
!
WARNING! This bench is not electrically insulated and is therefore not suitable for electrical repairs of any sort.
F
DO NOT use the bench for any purpose other than that for which it is designed.
%
DO NOT do work on the bench without the workpiece being adequately secured. Use clamps or a vice (not included) to secure the
%
workpiece. Available from your Sealey dealer.
DO NOT use the bench out of doors.
%
DO NOT get the bench wet or use in damp or wet locations or areas where there is condensation.
%
DO NOT clean the bench with any solvents which may damage the paint surface.
%
2. CONTENTS
2.1 Do not attempt to move the unassembled bench in its box on your own. Please ensure that you have adequate manpower or lifting /
transit equipment to place the box in the area in which you intend to do the assembly. Ensure that the box is the right way up by
referring to the symbols printed on the side of the box.
2.2 Open the box and remove the loosened staples from the packaging to avoid them catching your clothing or causing cuts and abrasions.
2.3 Remove all parts and fixings from the box. Ensure that you have adequate help to remove the bench top from the box ( It is too heavy
for one person to safely lift.)
2.4 Check the contents against the parts listed above. Should there be any damaged
or missing parts contact your supplier immediately.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required
for any claim. INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
AP1010.V2
INSTRUCTIONS FOR:
STEEL TOP WORK BENCHES
AP1015.V2
fig. 1
AP1020.V2
CONTENTS
ITEM / PART * QUANTITY
STEEL WORKTOP (1)
SHELF (1)
LOCK AND KEYS (1)
*AP1010.01
DRAW WITH BEARINGS (1)
*AP1010.02
LEGS (SET OF 4) (4)
*AP1010.03
DRAW RUNNER
BEARINGS (4)
PACK OF FIXINGS
M17 BOLTS (18)
M17 NUTS (18)
SERRATED WASHERS (14)
AP1010.V2, AP1015.V2, AP1020.V2 - 1 - 060203