Connecting And Preparing Your Tv Checking Parts; Using The Stand-Base; How To Assemble The Stand-Base (Depending On The Model); Assembling The Cables - Samsung 5 Series User Manual

Connecting and Preparing Your TV
Checking Parts
Owner's Instructions Remote Control/
Screw (4ea)
Ferrite CoreThe ferrite cores are used to shield the cables from interference.When connecting a
N
cable, open the ferrite core and clip it around the cable near the plug.

Using the Stand-Base

Two or more people should carry the PDP. Never lay the PDP on the floor
N
because of possible damage to the screen. Always keep the PDP upright.
The PDP can rotate 20 degrees in right and left directions.
N
How to assemble the Stand-Base
Using the 4 screws for securing the stand base and the monitor, firmly attach the
monitor to the stand base.

Assembling the Cables

Enclose the cables in the Holder-Wire Cable so that the cables are not visible through the
transparent stand.
Power Cord
AAA Batteries
(2ea)
Cover-Bottom Holder-Ring (4ea)
(Refer to page 41)
Warning
Firmly secure the stand to the TV before
moving it, as the stand may fall and could
cause serious injury.
Two or more people should carry the TV.
N
Never lay the TV on the floor because of
possible damage to the screen. Always
store the TV upright.
The product colour and shape may vary
N
depending on the model.
Cloth-Clean
Ferrite Core for
Power Cord
(depending on the model)
In case of installing your TV on the wall, close the
cover (1) on the stand-base connection part using
two screws for hiding.
English - 4
Holder-Wire Cable Warranty Card/Safety
Guide Manuale (Not
available in all locations)
Ferrite Core for
Headphone
-20° ~ 20°